Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WDF310PAAT0

WDF310PAAT0 Whirlpool Dishwasher - Overview

Get Parts and Repair Help for WDF310PAAT0

If you know the dishwasher repair part you need, you can browse the list of all parts on the WDF310PAAT0, or you can search by name or part description. You can also find your part by where it is located on the WDF310PAAT0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for WDF310PAAT0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$38.65

Heating Element

This heating element is designed to monitor and control the heat of the water that enters the dishwasher. It is located at the bottom of the dishwasher. If your dishwasher is not d...

$56.56

Door Gasket with Strike - Black

This product contains both the door gasket and the door strike. The function of the door gasket on your dishwasher is to provide a seal between the tub and the door. The door strike serves as a mechanical actuator for door switch operation and provides door tension for a proper seal. If you notice that your refrigerator is leaking, the door will not latch properly, or it is not cleaning dishes properly, you may need to replace the door gasket. This repair is as simple as removing the old gasket from the channel on the edge of the dishwasher tub, and replacing it with the new one. This product is made of black rubber.

$6.12

Rack Track Stop

The rack track stop on your dishwasher is designed to stop the dish rack at the appropriate place when opening and closing the rack. If your dishwasher is not cleaning your dishes ...

$11.43

Mounting Bracket

The mounting bracket is sold individually, without screws. This part secures the upper side of the dishwasher to the underside of the counter or cabinet to prevent the dishwasher from moving, shaking, or tilting forward. The bracket is made entirely of metal. It is recommended to check all brackets, if applicable, because they often wear at the same rate and both may need to be replaced. This is an OEM part that is sourced from the authentic manufacturer. Tools needed are a pair of needle nose pliers and a screwdriver.

$4.89

Rubber Washer

The rubber washer is a part which is specific to dishwashers and should not be substituted by a similar part. It works with the heating element to seal the receptacle opening where...

$65.70

Drain Pump - 120V 60Hz

The pump ejects the water from the unit.

$18.32

High Limit Thermostat

This part acts as as safety mechanism that keeps the dryer from overheating. Once the dryer temperature reaches a certain point, this part will shut down power to the heating eleme

$4.40

Friction Sleeve

This part helps to keep your door quiet when it opens and closes.

$16.56

Retainer Clip - Black

This part is used to hold the access panel in place. Sold individually.

$3.02

Cover Screw

Sold individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

dishwasher not draining after wash cycle

  • Customer: Andrew from Alexandria, VA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 284 of 314 people found this instruction helpful
Caviat: The actual repair is less than 15 minutes, but I spent a lot of time playing with it before I figured out it was that easy and fast. You don't need to remove the dishwasher from the counter to do this. And it will probably help to look at the new part closely so you can understand where the retainer clip is to press it and release the old pump.
... read more

Heater element broken.

  • Customer: Dennis from Sedro Woolley, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench set
  • 124 of 132 people found this instruction helpful
Step 1: Remove the screws in the bottom of the countertop.

Step 2: Remove the screws holding the bottom kickplate.

Step 3: Loosen leveling legs.

Step 4: Pull dishwasher out of hole.

Step 5: Unlplug dishwasher.

Step 6: Disconnect wires from bottom of element in back.

Step 7: Remove plastic nuts... read more

The door gasket stuck to the door a pulled out of place after every use

  • Customer: Penny from Manchester, MI
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 112 of 136 people found this instruction helpful
Worked the new gasket into the groove with a smooth screwdriver and my fingers. No leaks and it stays in place. Parts Select had the right part and I got it fast read more