WDB635RBS0 Westinghouse Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
dishwasher door opens to floor
just removed the screws holding the dishwasher in and pulled it out about 6 inches and attached the new springs one on each side. very easy and simple. no tools needed to attach new springs. be sure to cut off power to dishwasher before attempting this.
Parts Used:
-
MAURICE from SAUTEE NACOOCHEE, GA
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
melted rubber
Removed clips, slid old racks out and new in.Very easy.
Parts Used:
-
kenneth from breese, IL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
The old rack was rusting and the rust was flaking off in the Dishwasher makking a mess.
Rolled the old lower rack out and rolled the new lower rack in, took less than a minute and it was a done deal.
Parts Used:
-
George from Raynham, MA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
part of plastic coating melted, medal rusted
It was very easy. I am a 7yr. old widow with a bad right shoulder and I printed off the instructions another customer described, took the copy to the kitchen and followed his step by step instructions. It was simple. It would have been quicker if I had more strength in my hands.
Parts Used:
-
Imogene from Paducah, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No water
Tested main water supply first and it checked out, next thing was the valve got a new one took old one off, flushed the line a few times to get dirty deposited water out, stuck the new inlet valve on and ran the dish washer and it worked, really a pretty easy thing to do anybody can do it and it will save you a couple hundred bucks in the repair mans labor and his cost for parts, deffinetly a must do yourself job. Got my part in two days from when I ordered it.
Parts Used:
-
Bret R. from Angola, IN
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Pliers, Wrench (Adjustable), Wrench set
Was this instruction helpful to you?
Thank you for voting!
Bottom door gasket had fallen out.
I had tried to put the old gasket back in place while waiting for the new to arrive and in doing so, the gasket had gone up beyond reach.We removed the screws on the inside of the door and I was able to reach and remove the old gasket. After replacing the screws, I then simply slid the new gasket into place. Easy! If I can do it, anyone can. Flo
Parts Used:
-
Flo from Hannibal, MO
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Door Leaking
All I have to say is paets select is the best company I have delt with in the last 20 years
Parts Used:
-
willis w from broomes island, MD
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
the tub was leaking at the right front corner
-
Raymond from El Paso, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Replaced Cover and Stem Assembly Frigidaire DW
Your site is awesome.. not only show the parts but a video for the repair as well.. very smart site.. I will be back.. The repair was quick and easy. thank you..
Parts Used:
-
jamie from Fairfield, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Lower Sprayer Arm Wouldn't Stay On
Took lower tray assy. Out and took 3 screws out of cover and stem assy. And replaced old with new. Took me about 15 min. Part was perfect match so job was a piece of cake.
Parts Used:
-
Charles from Del Valle, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Nutdriver
Was this instruction helpful to you?
Thank you for voting!
Door Leaked At The Bottom Corners
Pull the old door seal down and out starting at one end. Push the new seal back in, noting the small notch location. Done!
Parts Used:
-
Jason from Ferndale, WA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Lower rack rubber coating split open in several places.
Opened box, removed new bottom rack with wheels included and placed on bottom shelf. No problems and was simply as that. Great buy and great communications by Part Select with me until part was delivered. Will use again :-)
Parts Used:
-
Frank from San Antonio, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
No Problams
It was one of most easy fix I done, took bottom off unplug wires and unscrew two nuts, it came right out install new one two nuts and wires, check for leaks. It that easy,part fit exact.
Parts Used:
-
michael from prestonsburg, KY
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
Leak at bottom of door
Remove old gasket from tub, soak new gasket in hot water for a few minutes then install starting from center top of tub, when done installing close door for 24 hours, then try to see if leak fixed.
Parts Used:
-
Dunstan from Port St.. Lucie, FL
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
wheel rusted off.
ordered on line, you shipped, opened box and removed old installed new, Saved $100.00 going on line.
Parts Used:
-
Dale from Mesa, AZ., AZ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!