WDB11NRDS3 Westinghouse Dishwasher - Instructions

I removed the 2 screws that hold the dishwasher in place. Slide out the unit just far enough to access the brass nuts on the heating element. Pulled off the wire, and replaced the broken nut with the new nut. Replaced the wire, slide the unit back into place and reattached the 2 under counter screws. Done!!!

Replaced bottom gasket, still leaks. This was not the problem. Will have to keep looking for source of water leak. Bottom gasket installed really easy. Just pulled the old one out and inserted the new. Just was not the source of leak.

removed spray arm, located damaged ears on spray arm, ordered the part, received it in 2 days (wow great service)and installed it the same day.

I just pulled the old one out and installed the new.

Repaired with installation instructions from PARTS-SELECT. Worked perfect!

Very easy project. The bottom gasket slides out very easily and inserts just as easy. Just make sure you push it in all the way. Tub gasket is also easy - lineup the mark on the gasket (shows where the center is) with the top door latch and run it in the insert on either side. Cut off the excess but make sure you run it all the way around letting a portion stick out horizontally at the bottom (too short and the door will still leak). Run a quick wash cycle to make sure it seals properly and you're done - no tools needed.

Pulled out the gasket,trimmed the gasket to fit and alittle pressure to put.it in place, very easyto do. No worries any one can do this and savek yourself costly repair person.

Cakewalk, replacing a water inlet valve is self-explanatory. Take the old one off, put the new one on .. that's pretty much it.

replaced door latch assembly

The bottom gasket was really delivered quickly for the Xmas season. Watched the online video for removing and replacing the Bottom Gasket. Five minutes later was loading dishwasher for the trail run. No leaks dishwasher back online.

Replaced bottom and tub gasket

I replaced the bottom gasket and the tub gasket. replacing them both was very easy. I pulled the tub gasket out by using a screw driver and popping out a section then pulled it out. Installed new one by just pushing it in. Bottom gasket was simple as well. There was a notch in the gasket on the right side so you can't screw it up on which side goes where. Pulled the old one out and pushed the new on in. I found it easier to install the right side with the groove first. Both gaskets helped. However dishwasher was still leaking. Another person had mentioned that the spinner that shoots the water on the bottom, had a hole in it and was shooting water towards the door. I examined both of them and found that the bottom one had a bigger hole on the very end. It looked like it hit something and made the hole bigger. I temporarily put duct tape over it and it has't leaked. Plan on ordering the new part today.

I ordered both upper & lower from PartSelect. The lower is a simple switch out. Re-used the original flatware holders. On the upper you have to remove the water spinner. Unscrew a nut and unsnap a cylinder. Finger work. Do it in reverse for the new rack. Same with the wineglass holders. I also unsnapped and saved the rollers from original. Only disappointment is both new racks had no folding spines like original ones.

ordered and replaced in 5 minutes

I just had to remove arm and reinstall the new one.That is not hard the great thing was that I tried to call sears repair store,45min.no answer so I drove to it. They didnt have part but could order it from frigidaire would take 10 days and 12.99 shipping. I came home checked Frigidaire website, same price and shipping.Then I looked on your website part was half the price and less than have for shipping. Received the part in two days and that included New Years day. Excellant business and super savings.thanks