WDB11NRDS0 Westinghouse Dishwasher - Instructions

Very easy project. The bottom gasket slides out very easily and inserts just as easy. Just make sure you push it in all the way. Tub gasket is also easy - lineup the mark on the gasket (shows where the center is) with the top door latch and run it in the insert on either side. Cut off the excess but make sure you run it all the way around letting a portion stick out horizontally at the bottom (too short and the door will still leak). Run a quick wash cycle to make sure it seals properly and you're done - no tools needed.

Pulled out the gasket,trimmed the gasket to fit and alittle pressure to put.it in place, very easyto do. No worries any one can do this and savek yourself costly repair person.

Cakewalk, replacing a water inlet valve is self-explanatory. Take the old one off, put the new one on .. that's pretty much it.

replaced door latch assembly

The bottom gasket was really delivered quickly for the Xmas season. Watched the online video for removing and replacing the Bottom Gasket. Five minutes later was loading dishwasher for the trail run. No leaks dishwasher back online.

Replaced bottom and tub gasket

I replaced the bottom gasket and the tub gasket. replacing them both was very easy. I pulled the tub gasket out by using a screw driver and popping out a section then pulled it out. Installed new one by just pushing it in. Bottom gasket was simple as well. There was a notch in the gasket on the right side so you can't screw it up on which side goes where. Pulled the old one out and pushed the new on in. I found it easier to install the right side with the groove first. Both gaskets helped. However dishwasher was still leaking. Another person had mentioned that the spinner that shoots the water on the bottom, had a hole in it and was shooting water towards the door. I examined both of them and found that the bottom one had a bigger hole on the very end. It looked like it hit something and made the hole bigger. I temporarily put duct tape over it and it has't leaked. Plan on ordering the new part today.

ordered and replaced in 5 minutes

I just had to remove arm and reinstall the new one.That is not hard the great thing was that I tried to call sears repair store,45min.no answer so I drove to it. They didnt have part but could order it from frigidaire would take 10 days and 12.99 shipping. I came home checked Frigidaire website, same price and shipping.Then I looked on your website part was half the price and less than have for shipping. Received the part in two days and that included New Years day. Excellant business and super savings.thanks

I viewed a very short video on how to replace the lower gasket on the website which was extremely useful. I then ordered the part via standard shipping and it arrived very quickly. I used the flat head screwdriver to gently loosen the old gasket which has mineral buildup on it and was stuck into place. Sliding the new one in was a snap. This was one of the best sites as you could search for the part by describing the problem. I would definitely use it again!

R&R the tub gasket and the door gasket. Repair not effective, it still leaks.

Ordered a bottom gasket and replaced it. Started dishwasher and had same leak. Found out that the lower spray arm had a hole in it from the heating element and was spraying water directly at lower part of door. Replaced lower spray arm, problem solved!!

removed old part and slide new one in , so simple

Took bottom panel off dishwasher -- used stubby screwdriver to remove bracket from old thermostat, intalled and connected new thermostat, replaced bracket -- easy. Parts schematic on website made locating and replacing part very simple.

Pulled out bottom gasket, inserted new gasket. Max about 5 min. Pulled out tub gasket,cut new gasket to match old gasket and pressed into tub.Max about 10 min. Spent more time putting kick plate back on.