Models > WDB11NRDB3 > Instructions

WDB11NRDB3 Westinghouse Dishwasher - Instructions

All Instructions for the WDB11NRDB3
301 - 315 of 468
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
dishwasher leaked by bottom of door
Removed door covering. Removed door (it was nice to have a helper for this as the hinges spring closed as the screws are removed). Flipped door over, leaving the wires attached. Removed the bottom seal, and put new one in. This looked like it would slide out by a side, but it actually pulls straight down. It is notched, so there isn't a way to put new one in the wrong way. Attached door (again helper a bonus). Attached door cover.
Parts Used:
Dishwasher Bottom Door Gasket
  • Mark from Raleigh, NC
  • Difficulty Level:
    Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Screw drivers
0 of 4 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
was brocken
just replace
Parts Used:
FLOAT
  • Aleksandr from West Palm Beach, FL
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
8 of 32 people found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaking arond the door.
I checked with the possible causes and ordered the gasket suggested. I then clicked on how to replace the gasket and followed the directions given. Pretty simple.
Parts Used:
Dishwasher Bottom Door Gasket
  • David from Leesburg, FL
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Water discharge (around door) during Wash Cycle
After reading some "Suggested Installation Instructions" on the Parts Select Website, I felt at ease tackling this job. After opening the door, I simply pulled-out the existing door gasket. The installation involved simply pressing in the new gasket with my finger and insuring it was properly seated. The only tool I had to use was a pair of scissors to cut the excess length as I pressed it in. REALLY APPRECIATED THE SIMPLE INSTALLATION INSTRUCTIONS as I had never done this particular task.
Parts Used:
Dishwasher Tub Gasket - Gray
  • Gary from Roseville, CA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
water inlet valve was leaking
Could not identify the breaker for the dishwasher so I turned off the whole house. Turned off the water supply. Removed the leaking valve fairly easily - the clamp that holds it in place was a little tricky. New valve went on easily & again the clamp was a little harder. It was successful since there have not been any further leaks. Location of the valve & having to lie on floor to do repair was a factor in the ease of installation.
Parts Used:
Water Inlet Valve - 120V 60Hz
  • Jack from Wilton, ME
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
Tub Wheels were worn & broken
Got the parts in a DAY! Wheels were broken and worn causing top tray to slip off runners- new wheels were easy to put in-used the screwsfrom the old ones and banged out the job in about 20 minutes, including letting my son help. Thanks Partselect, you've hooked a new DIY'er (my son)
Parts Used:
ROLLER TUB Gray
  • James from Hyde Park, MA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
leaking all over the floor
It was so easy that I could not imagine that it would work, but it did. Also, thank you for your great service. Finding the correct part on your site and quick delivery made the whole process very easy.
Parts Used:
Dishwasher Bottom Door Gasket
  • Raymond from Harrah, OK
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Leaking water under door
Your video described the way to install the gasket perfectly.
Parts Used:
Dishwasher Bottom Door Gasket
  • George from Angola, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaks at the bottom front.
I took a shot and ordered this $12.00 part plus shipping. The part looks better then the old part and it was easy to replace but it did not fix the leak. I think its a bad design because there is a gap in the middle of gasket where water can flow thru into this channel and then it overflows. So for now we just put a pan underneath to catch overflow because the rest of the dishwasher still works great.
Parts Used:
Dishwasher Bottom Door Gasket
  • Jerry from Fremont, NE
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
leaking water through the door onto the floor.
removed inner door panel, seal slid out easily, installed new one, and inner door panel, no more leak! parts came quickly.
Parts Used:
Dishwasher Bottom Door Gasket
  • Harold from Grants, NM
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
standing water after done, poor rinse, dirty dishes.
unscrew top tabs of dw pull out,,unplug.. bail out water..disconnect drain and water at house connections..turn dw on it's side and unscrew old pump..ply off connectors..install new pump..bam!!
Parts Used:
Drain Pump
  • Tucker from Woodward, PA
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    30 - 60 mins
  • Tools:
    Pliers, Screw drivers
Was this instruction helpful to you?
Thank you for voting!
Dishwasher did not drain
I turned the power. Unhooked the dishwasher and flipped on the back exchanged drain pump. Perfect. Works like charm.
Parts Used:
Drain Pump
  • Jason from North Little Rock, AR
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
  • Tools:
    Screw drivers, Wrench (Adjustable)
Was this instruction helpful to you?
Thank you for voting!
Lid on detergent dispenser wouldn't stay shut
Found breaker switch for dishwisher and turned it off. Removed one screw on each side of bottom of door. Front panel slid off. Removed the two wires on dispenser, then took out the six screws. Pulled entire piece out from the inside of door. Put in new dispenser, attached wires (white on inside and red on outside). Put in the six screws and including the one with the little hook that holds the wires. Slid the front door panel back on and replaced the two screws (one on each side of bottom of inside door). Flipped the breaker switch back on. Approximately 25 minutes. Very easy, thanks to the person who wrote his/her instuctions previously.
Parts Used:
Detergent and Rinse Dispenser with Cap
  • Katherine from Fortville, IN
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers
Was this instruction helpful to you?
Thank you for voting!
The cap fell off and was melted on one side--therefore the rinse solution kept draining out.
I was determined to find and replace the part myself. Much to my surprise, others had had the same problem! Thanks to the reviews on this website gave me the "courage" to do it myself!
Parts Used:
Rinse Aid Cap
  • Nancy from Williamsville, NY
  • Difficulty Level:
    Really Easy
  • Total Repair Time:
    Less than 15 mins
Was this instruction helpful to you?
Thank you for voting!
My dishwasher was leaking from and electrical connection at the heating element
There was an excellent "how to" video on the internet which also pointed me to the part I needed. I did not even remove the dishwasher as recommended. I removed the lower kick plate, removed the power connector at the leaking input, removed the bad nut and installed the new nut.
Parts Used:
Heating Element Brass Nut
  • Kevin from Old Orchard Beach, ME
  • Difficulty Level:
    Easy
  • Total Repair Time:
    15 - 30 mins
  • Tools:
    Screw drivers, Wrench set
Was this instruction helpful to you?
Thank you for voting!
All Instructions for the WDB11NRDB3
301 - 315 of 468