Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WCSE3100A1WW

WCSE3100A1WW General Electric Washer - Overview

Get Parts and Repair Help for WCSE3100A1WW

If you know the washer repair part you need, you can browse the list of all parts on the WCSE3100A1WW, or you can search by name or part description. You can also find your part by where it is located on the WCSE3100A1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WCSE3100A1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.84

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$8.21

D-Shaped Knob Insert Clip

Sold individually.

$9.63

Agitator Coupling Kit

Washing machine agitator drive bell with bolt. It connects the transmission drive shaft to the agitator base. *NOTE: Hold down bolt not sold separately.

$32.93

AGITATOR ASM

This plastic dual action agitator is white in color. It is approximately eighteen inches tall with a base diameter of about 12-1/4 inches.

$12.71

Drain Hose - 4 1/2' Long

$7.52

Tub Seal

The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably be installed by a qualified technician.

$11.92

Selector Knob with Clip

This knob accepts a D-shaped shaft. Sold individually.

$44.08

Drain Pump and Motor Assembly

This pump helps expel water from the washing machine and is activated after the spin speed is maintained for a specific period of time.

$11.33

V-Style Drive Belt

$6.59

Tub Bearing

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

One of eight clips broke off of the agitator assy allowing the assembly to come lose on heavy loads.

  • Customer: Paul from Carneys Point, NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 570 of 597 people found this instruction helpful
I replaced the coupling by only having to remove one bolt with a socket wrench. Once replaced I installed the new assy over the coupling making sure ro align the splines then pushing down until the assy snapped into place. Easy. read more

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 482 of 488 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 374 of 377 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more