Models > WCCB1030H2WC

WCCB1030H2WC General Electric Washer - Overview

Get Parts and Repair Help for WCCB1030H2WC

If you know the washer repair part you need, you can browse the list of all parts on the WCCB1030H2WC, or you can search by name or part description. You can also find your part by where it is located on the WCCB1030H2WC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WCCB1030H2WC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.71

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$3.00

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$53.39

PUMP

$37.23

Dual Action Agitator

This does not come with the fabric dispenser - must order separately or use original part.

$11.54

6-Rib Drive Belt

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$7.23

SEAL TUB

$6.62

Agitator Coupling

Bolt not included. This part connects the transmission drive shaft to the agitator base.

$3.00

Tub Bearing

$7.45

Hub Nut

$3.14

Hub Washer

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing Machine was not draining water from tub.

  • Customer: Gerald from Midlothian VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 152 of 161 people found this instruction helpful
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor)
2. Removed the... read more

The Hub Under the Spinner basket broken/ Deteriorated

  • Customer: Joe from Lucedale MS
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set
  • 49 of 65 people found this instruction helpful
Removed front cover, Control panel, top Cover, slasher unit, all very smiple stuff. the hub was broken and the spinner basket came right out. One half Hub attached to Spinner, Other half attached to Hub drive shaft. removing the Hub nut was the hard part. tried impack & socket, No luck. in removal. Had to usr Hammer & Chisel and bust Old Alum... read more

broken drive belt

  • Customer: jon from barry IL
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 43 of 51 people found this instruction helpful
To diagnose, first I unhooked the washer: power, water supply, and drain pipe. I then slid the washer out, laying it on its front. With nutdriver, I unscrewed two screws that held the other end of the drain tube and removed it completely. Then, again with the nutdriver removed 4 screws from the back near the legs, two in between the legs in the middle, and... read more