Quick Question!

Have you ever purchased from PartSelect.com before?

Models > WBXR1090A1WW

WBXR1090A1WW General Electric Washer - Overview

Get Parts and Repair Help for WBXR1090A1WW

If you know the washer repair part you need, you can browse the list of all parts on the WBXR1090A1WW, or you can search by name or part description. You can also find your part by where it is located on the WBXR1090A1WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for WBXR1090A1WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.52

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$8.21

D-Shaped Knob Insert Clip

Sold individually.

$9.63

Agitator Coupling Kit

Washing machine agitator drive bell with bolt. It connects the transmission drive shaft to the agitator base. *NOTE: Hold down bolt not sold separately.

$12.71

Drain Hose - 4 1/2' Long

$11.92

Selector Knob with Clip

This knob accepts a D-shaped shaft. Sold individually.

$7.52

Tub Seal

The main tub seal is located between the transmission and the outer tub. It's the primary water seal in the outer tub for the transmission-shaft. This seal is difficult to replace and should probably be installed by a qualified technician.

$6.59

Timer Knob Clip

$7.40

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$9.09

V-Style Drive Belt

$8.01

Timer Knob with Clip

White in color.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replaced broken START knob on dryer.

  • Customer: SAM from ROCK HILL, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 485 of 491 people found this instruction helpful
Slid off the old START knob, then pushed on the new START knob.

I created and printed a label on my computer for use with the time selector dial, which must be set at or beyond 10 minutes, before turning the START knob.

I made a label that says "Minimum" with a red arrow that points past the 10 minute setting on the time selector dial.<... read more

The inside of the Selector Knob was stripped

  • Customer: Frank from Irvine, CA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 374 of 377 people found this instruction helpful
Removed the damaged knob and replaced it with the new knob. Very ease read more

broken dampening strap and loose agitator

  • Customer: molly from laguna niguel, CA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Socket set
  • 212 of 222 people found this instruction helpful
first remove the front washer cover by finding the two pressure clips that hold it to the top lid. gently push the putty knife into the clips one at a time. this will raise and separate them from the front panel. the panel will tilt forward and u can now remove it from the bottom clips by sliding it up and out. to open the top cover u remove the two 1/4 in s... read more