This is a 120 volt, 60 hertz drain pump assembly for a washing machine. It is a genuine OEM part. This pump helps expel water from the washing machine, and is activated after the spin speed is maintai...
This adjustable leg, also known as a levelling leg, is a genuine OEM part supplied by Samsung for use with washing machines. The leg supports the washing machine by ensuring that it is level and balan...
This selector knob, also called the control knob, is used to choose different settings and cycles on your dryer. This knob is silver in color and is found on the control panel. If it becomes damaged, ...
Ask our experts a question about this model and we'll get back to you as soon as possible!
1 question answered by our experts.
Sort by:
< Prev
1
Next >
Search filter:
Clear Filter
Your search term must have 3 or more characters.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Sorry, we couldn't find any existing answers that matched.Try using some different or simpler keywords, or submit your new question by using the "Ask a Question" button above!
Joe
July 27, 2023
How do I remove the top casing of the machine to replace damper rods?
For model number WA476DSHASU
Hi Joe, thank you for getting in touch. Based on our research, you may need to first remove the screws in the back holding the brackets in place. Then, use a putty knife, insert it into the gap between the top panel and the washer frame at the front to unlock the tabs holding the top panel. Now, you can raise the top panel and support it with a wooden block so you can replace the damper rods. We hope this helps!
Was this helpful?
Thank you for voting!
< Prev
1
Next >
✖
Ask a Question
Ask our experts a question on this model and we'll respond as soon as we can.
Watched the video, procedure was simple and as depicted on the video. Started by using a wet shop Vac to the discharge hose and sucked as much dirty wash water out as possible. Removed the pump,and found the motor did not turn freely. Removed the motor (3 screws) and replaced the motor with new part. Reassembled the washer, everything wor
... Read moreked as it should. After about 3-4 loads of laundry, the "Not Draining" code / problem returned. Again, sucked out the water with the Shop Vac. Checked the Filter /Cleanout and found it completely packed with MUD. Cleaned that out, and again disassembled the washer. The pump was removed and the remaining muddy gunk was cleaned from the impeller. The 3 drain lines that attached to the pump were inspected for blockage/obstruction and flushed of any muddy residue. Reassembly was quick and easy, and the washer has worked well since. I have no idea how the dirt got into the system with enough dirt to gunk up the system. Recommend keeping more frequent inspections of the cleanout trap.
NOTE: this repair requires OEM part number DC60-50003A and what was originally provided was 6021-001573. This is important as Part Select has this mixed in their Database and I made them aware.
Otherwise once you have the correct part the repair is simple. Open the top of the washer and remove the pulsator cap, there is a 10m
... Read morem bolt which is removed next, the pulsator pan (believe this is correct) can be removed with a flat head screw driver. Do so by placing the screw driver in one of the groves by where the bolt was. Once this is removed that is where this part will be. I didn’t have to remove since mine was in pieces but it comes off/goes on counter clockwise. Repeat steps to put everything back together.