Models > W30400P

W30400P Jenn-Air Oven - Overview

Parts and Repair Help for models starting with W30400P

If you know the oven repair part you need, you can browse the list of all parts for models starting with W30400P, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for W30400P parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with W30400P

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$36.91

Door Hinge

This hinge is located on each side of the oven door.

$2.70

Screw

This screw is sold individually.

$18.07

2 Piece Broiler Pan

The top of this part is now black.

$50.56

Bake Element

This bake element is found on the bottom of the oven.

$43.83

Oven Rack

Sold individually.

$28.13

Light Lens

This part goes over top of the light bulb.

$53.52

Temperature Probe

This temperature probe consists of two ends joined together by an insulated wire. The small end, the jack, plugs into the range, while the longer end, the probe, is inserted into the meat.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 88 of 100 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

Lost all clock and timer display

  • Customer: John from Kuna ID
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 61 of 66 people found this instruction helpful
Removed the 4 phillip head screws that hold the trim plate on the bottom of the display panel (and you probably could skip this step).
Next, I removed the knobs from the front of the display panel.
Then I removed the 4 phillip head screws that were located (1 each) behind the knobs.
Finally, I removed the 4 hex head screws from the bottom of t... read more

F1-1 code

  • Customer: charles from marstons mills MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 35 of 42 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more