Quick Question!

Have you ever purchased from PartSelect.com before?

Models > W2780W

W2780W Jenn-Air Wall Oven - Overview

Parts and Repair Help for models starting with W2780W

If you know the wall oven repair part you need, you can browse the list of all parts for models starting with W2780W, or you can search by name or part description. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for W2780W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with W2780W

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.07

Light Bulb - 40W

Sold individually.

$28.90

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$2.61

Screw

This screw is sold individually.

$5.10

Screw, 8/18 x 3/8

This screw is sold individually.

$21.68

2 Piece Broiler Pan

The top of this part is now black.

$53.27

Bake Element (16" long x 17" wide)

This bake element is 17 inches wide. It has a terminal depth of three inches, and a total element length of ninteen inches. This element is intended for use with some electric ovens.

$40.19

Oven Rack

Sold individually.

$8.65

Light Bulb Socket

This light bulb socket is located inside the oven cavity.

$3.37

Screw

This screw is sold individually. Size: 8-32 x 1/4 inch.

$27.41

Broiler Pan

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven not holding 350 F, when cooling the coils did not reheat

  • Customer: David from Westford, MA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 112 of 130 people found this instruction helpful
Removed the oven door by opening slightly, then pic door up to remove. Remove 2 screws holding oven sensor in place, gently pull on sensor to remove, had to remove about 8 inches to get at plastic connector. Unplug connector, had to use an adapter cable supplied with the PartSelect kit to install new sensor, push cable back into opening, reinstall 2 screws. ... read more

F1-1 code

  • Customer: charles from marstons mills, MA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 48 of 62 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the sensor out about 3 inches and disconnected the two wires. Next, I connected new sensor and screwed the new sensor back in place. One area for caution. Make sure that the electrical connection is pushed in past the insulation on the back side of the oven. Failure to do so will ... read more

Repeated oven temperature sensor fault codes.

  • Customer: David from Arlington, VA
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 24 of 28 people found this instruction helpful
First I removed the two philips screws inside the oven that hold the element in place. Then I pulled the sensor out and the two insulated wires through the hole to reveal the plastic connector. I unsnapped it from the connector and replaced it with the new element. Then, behind the oven, I removed five or six philips screws on the right side of the large ... read more