Quick Question!

Have you ever purchased from PartSelect.com before?

Models > W210

W210 Jenn-Air Wall Oven - Overview

Get Parts and Repair Help for W210

If you know the wall oven repair part you need, you can browse the list of all parts on the W210, or you can search by name or part description. You can also find your part by where it is located on the W210 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for W210 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the W210

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$46.44

Bake Element (16" long x 16" wide)

This spade style bake element with push on wire terminals is 16 inches wide. It has a terminal depth of three inches and a total element length of nineteen inches. This element comes with an instructions sheet and is intended for use with electric ovens.

$22.22

2 Piece Broiler Pan

The top of this part is now black.

$2.87

Screw (4)

Sold Individually.

$35.07

SEAL- DOOR

This oven door seal is seventeen and a half inches long. It is made of rubber and has a metal hook on either end to hold it in place. This seal sits on top of the glass window pane

$37.41

Oven Rack

Sold individually.

$100.54

Interior Door Glass Window Assembly

$31.72

Vertical Side Door Seal

$39.34

Oven Rack

Sold individually.

$28.19

Broiler Pan

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

bottom heating element in oven disintegrated

  • Customer: DENISE from GERMANTOWN, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 42 of 45 people found this instruction helpful
First I removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires. I threw away the old pieces.

Then I connected the two wires on the new element. I pushed the wires back in the insulation in the wall of the cabinet. Then I inserted the two screws and tightened them in.read more

Oven heating element blew out

  • Customer: Shirley from Dallas, TX
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 20 people found this instruction helpful
Removed 2 screws, pulled element out. My husband used an ohmmeter to see if the electricity needed to be turned off. It showed no voltage. He could not remove electrical connectors by hand, so he used insulated pliers. When he touched the connectors, a shower of sparks covered the inside of the oven and tripped the breaker switch. Then we noticed the pl... read more

Element was burned through

  • Customer: Kevin from New London, OH
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 8 of 9 people found this instruction helpful
I used tiny amount of WD40 on old screws,let sit for 2 minutes. Tapped the screws(2) of them with a small hammer to wake them up, I had a cordless drill and they backed right out. Pulled the old element out, used needle nose pliers to pull connectors off of the element(wiggle gently) put the new element on, reinserted back in the oven,attached with new screw... read more