Models > W20FN2C

W20FN2C Magic Chef - Overview

Get Parts and Repair Help for W20FN2C

If you know the repair part you need, you can browse the list of all parts on the W20FN2C, or you can search by name or part description. You can also find your part by where it is located on the W20FN2C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your . We’ve also included any installation videos we have for W20FN2C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

SCREW

This screw is sold individually.

$2.70

Hose Clamp

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.70

Cover Screw

Sold individually.

$8.96

Leveling Leg and Pad

This part includes locknut.

$5.55

Screw

This screw is sold individually.

$20.79

Lid Switch Actuator - Black

This is part of the lid switch actuator mechanism and activates the lid switch, when the lid is closed, to start the wash cycle and when the lid is open, it stops the cycle.

$9.92

INLET HOSE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Intermittent problem with lid switch, no high speed spin/pump out

  • Customer: Linda from La Porte IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 22 people found this instruction helpful
Disconnect power, unsnap and raise machine top cover w/lid, remove old switch - two screws under lid, taking care to not drop loose actuator lever into machine. Remove control panel back and disconnect switch wire connector. Intall new switch, taking care to not drop loose actuator lever into machine, connect switch wires inside control panel. Replace pan... read more

Lid switch had deteriated over time and no longer made contact

  • Customer: James from Rochester NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
removed the screw holding the actuator, ordered the new part and replaced it when it arrived. Shipping was really fast and I even received it one day early. read more

Washer Spin Cycle Stopped

  • Customer: Diana from La Mirada CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 3 of 4 people found this instruction helpful
Removed the screw from the side of the lid of the washer. Took off the old Lid Switch Actuator and screwed in the new one. Took a little elbow grease because the old screw was tight but no longer than 15 minutes tops. read more