Quick Question!

Have you ever purchased from PartSelect.com before?

Models > W14EA1

W14EA1 Magic Chef Washer - Overview

Get Parts and Repair Help for W14EA1

If you know the washer repair part you need, you can browse the list of all parts on the W14EA1, or you can search by name or part description. You can also find your part by where it is located on the W14EA1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for W14EA1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the W14EA1

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.02

Hose Clamp

This hose clamp is used in a wide variety of household appliances. Most often it is found in washers, dishwashers, refrigerators, freezers, dehumidifiers, garbage disposals, or air...

$9.56

INLET HOSE

This hose can handle hot or cold water and is five feet long.

$3.00

Screw

This screw is sold individually.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

$9.14

Leveling Leg and Pad

This leveling leg, which includes a lock nut and a pad, is used to keep washing machines still and balanced. If your washer shakes and moves excessively, then this could be an easy...

$11.51

Spray Paint - 12 oz. - White

Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a protective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.

$5.83

Clamp

This clamp is sold individually.

$3.00

Screw, Ground

$28.69

Spin Bearing

$5.77

Spacer

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Machine making grinding noise and vibrating excessively

  • Customer: John from Silverton, CO
  • Difficulty: Very Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 0 of 0 people found this instruction helpful
Followed existing instruction to get tub and transmission out of the machine but we couldn't get the transmission free. Wound up taking the tub with the transmission attached to an appliance dealter who said we needed to remove the retaining clip on the bearing at the top of the transmission (inside the tub). We didn't have the tool to do that so we left i... read more

Pad missing from both front legs which made washer dance around the room

  • Customer: Michael from DeSoto, TX
  • Difficulty: Really Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Wrench (Adjustable)
  • 0 of 0 people found this instruction helpful
Easy as pie but had to cut one with hack saw to remove as it would not unscrew. Rust was the problem. Hack saw was the cure. Otherwise repair would have taken 5 minutes Washer now works as it did as a new appliance. read more