Models > W106B-C

W106B-C Jenn-Air Oven - Overview

Get Parts and Repair Help for W106B-C

If you know the oven repair part you need, you can browse the list of all parts on the W106B-C, or you can search by name or part description. You can also find your part by where it is located on the W106B-C by selecting a section below. We’ve also included any installation videos we have for W106B-C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

$2.70

Screw

This screw is sold individually.

$18.07

2 Piece Broiler Pan

$3.84

SCREW

$25.52

Broiler Pan

$4.46

Lock Indicator Light

$3.84

Light Bulb Socket

This light bulb socket is located inside the oven cavity.

$29.36

Thermostat Knob

This knob accepts a double-flat shaft.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lightening blew out the digital clock works and therefore we couldn't use the self clean oven.

  • Customer: Peter from Savannah GA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers, Socket set
  • 7 of 8 people found this instruction helpful
turned off electricity at the circuit breaker.Pulled stove out and looked at the way the control center was attached to the rest of the stove. Removed the knobs and 4 screws and the complete panel could be removed (or pulled out from the oven-wires are still all attached). Then checked with an electric meter to insure the power was off to all the wires. T... read more

clock not working--blank

  • Customer: JEFF from ORIENTAL NC
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
removed 4 screws holding entire face plate. Rolled face plate up on top of stove and left all wires attached (many). removed 4 screws adjacent to clock assy. Removed control knob just on either side of clock assy and removed control screws (2 on each). removed wires attached to clock assy and transferred new assy. Re-assembled and set clock time. read more

Oven door latch was bent and did not release or lock

  • Customer: Roy from Morgantown WV
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 6 of 10 people found this instruction helpful
Had to disassemble the top of the stove and the control panel on the front. I took digital pictures as I disassembled so I could refer to them when putting the stove back together, especially when disconnecting wiring. It took about 3 hours, but most of that time was spent thoroughly cleaning 16 years of baked on grease from places that are normally unacce... read more