VBSR3100G1WW Hotpoint Washer - Instructions

It was as simple as removing the front cover of the washer. After unpluging, using pliers, remove the two hoses on the pump and disconect the two power plug ins. Two bolts that mounted the pump to the frame of the washer were removed and the pump comes out. Re-install the same way with the new pump from partselect and it worked great.

ordered new one put on works like a new machine your repair website really helped.

My washer was full of water after it wouldn't drain as part of the wash cycle. I used a Wet/Dry vacuum to remove the water from the tub. Followed the video provided on this part page. When I pulled the hose from the wash tub to the pump at least a gallon of water that I was in the bottom of the tub and hose rushed into the base of the washer. It was an unexpected mess to clean up a the end of the job. Pump was fairly easy to remove from the washer, but reinstalling the hoses to the pump was slightly more challenging. The hose from the tub to the pump is about an inch too short to make this an easy fit. I had to have my wife hold the hose clamp open with the channel locks while I positioned pump onto the hose. After the hose was installed, the second hose was much easier to install. With the new pump the washer running like a champ!

I figured out the problem,watched the video instructor and i did it,couln'd be easier guy h

the repair was easy. I will be call you again, thank you.

just like the video showed/////only idid not kno the water would escape from one of the hoses when removed///video did not prepare me for this

remove screws from bottom of washer to remove the bottom of the washer so you can access the pump and motor assy. and remove two hose clamps.

Just traded out the hoses and installed washer and started washing. Also got the replacement hose in a very timely manner, in turn only without washer for 5 days total. Thank You

i took out the two screws that mount the pump to the base of the washer, then i took a pair of channel locks to disconnect the clamps on the drain lines. thats it. i put the new one in and it works great!

I took the old hose off and replaced it with a new one!!
It was an easy fix

"Thought" the belt was the problem - ordered new belt - waited for belt to arrive - opened washer. Belt was in perfect condition - problem is the clutch. Next time husband will verify problem before ordering parts.

First i removed the bottom of washer and removed clamps from two hoses connected to the pump , removed 2 pump bolts along with wire connector. Then reinstalled new pump, hoses and wiring and that was it. Very easy !

Replaced the water level pressure switch. Just a couple of screws to do this. Initially the washer did not appear to be fixed, but I disconnected and re-attached the electrical connectors and then it worked.

Pulled off front cover of machine. Unplugged unit. Used a channel lock (water pump pliers) to squeeze the hose clamp on the suction hose. Pulled hose off of pump suction. Did same for discharge hose. Some standing water came out onto floor of unit. Unscrewed 2 screws from base using nut driver. Pulled the 2 wires off of the stabs of pump. Re-installed new pump in reverse order. Unit back on line in 15 minutes, and works fine.

I took the two screws out that was holding the bracket and hose in place. I then pulled the hose out and then had a little bit of a hard time taking off the bracket (it was plastic and felt if I bent it to hard it would break) wiggling it down to the end of the hose. Re inserted the hose attached bracket, and I was done.
It would have cost me a lot more then $20.00 to have a repair man come in and fix it.
Love the service, delivered in two days.
Will use them again.