Models > VBSR3100G0WW

VBSR3100G0WW Hotpoint Washer - Overview

Get Parts and Repair Help for VBSR3100G0WW

If you know the washer repair part you need, you can browse the list of all parts on the VBSR3100G0WW, or you can search by name or part description. You can also find your part by where it is located on the VBSR3100G0WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for VBSR3100G0WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.71

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$3.27

Timer Knob Clip

$9.75

Drain Hose Extension - 4 1/2' Long

$53.39

PUMP

$37.23

Dual Action Agitator

This does not come with the fabric dispenser - must order separately or use original part.

$3.00

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$11.54

6-Rib Drive Belt

This drive belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$6.62

Agitator Coupling

Bolt not included. This part connects the transmission drive shaft to the agitator base.

$3.75

Split Ring

$7.45

Hub Nut

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Washing Machine was not draining water from tub.

  • Customer: Gerald from Midlothian VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 147 of 156 people found this instruction helpful
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor)
2. Removed the... read more

washing machine would not go through all cycles or agitate

  • Customer: Brian from Millerplace NY
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 101 of 131 people found this instruction helpful
After removing frt panel which prys off I checked for anything obvious like a loose belt. Then I jiggled the magnet switch located on the inside of the loading cover. I saw the machine start agitating the it stopped again when I stopped touching it. I ordered the new part and spliced it in with the wire crip tool. Now the machine is A ok. read more

washer was overflowing-- not registering that the tub was full

  • Customer: Angie from Saint Louis MO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 54 of 60 people found this instruction helpful
I replaced both the tube and the pressure switch and still no luck. turns out that i didn't need either part. the little box that the tube hooks on to at the bottom left of the tub had a clog in it. we disconnected the tube from the switch and just blew through it. the clog broke loose and my washer works again!! decided that i was leaving the new parts... read more