Models > UMV1152BAB

UMV1152BAB Maytag Microwave - Overview

Get Parts and Repair Help for UMV1152BAB

If you know the microwave repair part you need, you can browse the list of all parts on the UMV1152BAB, or you can search by name or part description. You can also find your part by where it is located on the UMV1152BAB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. We’ve also included any installation videos we have for UMV1152BAB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.46

Light Bulb - 40W

Sold Individually.

$6.46

Grease Filter

$2.70

SCREW

$5.49

Bulb - 120v 25w

$33.91

Cooking Tray

$12.61

Charcoal Filter

$44.27

Door Interlock Switch Kit

This kit contains 2 switches - 15 Amp - 125/250 Volt with 3/16" terminals.

$2.70

SCREW

$3.82

SCREW

$2.70

Cabinet Screw

This screw is sold individually.

Common Symptoms of the UMV1152BAB [Viewing 1 of 26]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

I HAD A HARD TIME FINDING THIS FILTER

  • Customer: Audrey from White Plains NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 520 of 581 people found this instruction helpful
I pulled out the old filters and just put in the new ones with ease, it was that simple. No screws was needed. read more

Replaced grease filters on Microwave

  • Customer: Dan from Nutley NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 68 of 130 people found this instruction helpful
It was a piece of cake....slid filters down and out, replace with new filters, slid down filter openings slightly and pulled filter up in to place. Done in less than one minute. read more

Burned out bulbs and grimey filters

  • Customer: DAVID from SAINT PAUL MN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 70 of 137 people found this instruction helpful
FIrst I removed the glass bulb cover, old bulbs, and old filters. Then I removed the 6 screws that held the lower cover in place, and bulb sockets. Then washed all parts an reassembled with new bulbs and filters. read more