Models > UKI1000AKX

UKI1000AKX Maytag Ice Maker - Overview

Get Parts and Repair Help for UKI1000AKX

If you know the ice maker repair part you need, you can browse the list of all parts on the UKI1000AKX, or you can search by name or part description. You can also find your part by where it is located on the UKI1000AKX by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your ice maker. We’ve also included any installation videos we have for UKI1000AKX parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Exact Part matches for your search term [Viewing 1 of 1]

KIT- ICE M

This part number matches the current model number "UKI1000AKX".

Sections of the UKI1000AKX [Viewing 1 of 1]

$2.70

Screw

Sold individually.

$15.79

Water Fill Cup and Bearing

$24.48

Thermostat with Clips

This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

$3.56

Plastic Tubing

1/4" Plastic tubing, 8 1/2 feet long.

$3.96

Compression Nut

$2.70

Water Hose Clamp

These tube clamps are sold individually. The screw is not included.

$2.70

Screw

This screw is sold individually.

$21.43

Ice Stripper

This part strips ice from the icemaker mold during the ejection cycle to prevent ice pieces from falling back into the mold.

$3.83

SCREW

$6.04

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The Bearing Cup Assembly was broken and ice would jamb against it during the ice making cycle.

  • Customer: David from Chester CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 56 of 69 people found this instruction helpful
I removed the ice maker from the refrigerator, by removing one screw on the underside bracket and loosening the two screws at the top side, then lifting the ice maker off the loosened screws. I then unplugged the electrical harness that supplies power from the refrigerator to the ice maker. I then disassembled the ice maker by removing the front cover whic... read more

No ice in ice trey

  • Customer: Wayne from Leesburg FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 41 of 47 people found this instruction helpful
The easiest thing to do was pull the ice make off. After taking the 3 screws out of the wall of the freezer, take a screwdriver (flathead) and push on the tab for the electrical plug and wiggle the cord out. Then you can take 3 screws out for the main cover and another 2 screws on the next cover. There's the part, pop it out and replace holding pins and star... read more

Icemaker arm was broken

  • Customer: Jason from Austin TX
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 21 people found this instruction helpful
The tiny piece of plastic that holds the wire that shuts off the icemaker, broke early on with our fridge (after just a few months.) We superglued it, but last week it bit the dust for good.

Once I got this part, I removed the freezer door and trays, and pulled the icemaker out by removing 3 flathead screws and unplugging the cables. Laying in the... read more