Models > TVF15FRGW01

TVF15FRGW01 Whirlpool Freezer - Overview

Get Parts and Repair Help for TVF15FRGW01

If you know the freezer repair part you need, you can browse the list of all parts on the TVF15FRGW01, or you can search by name or part description. You can also find your part by where it is located on the TVF15FRGW01 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for TVF15FRGW01 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the TVF15FRGW01 [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$31.53

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$2.70

Screw

This screw is sold individually.

$3.86

Touch-Up Paint - White

$2.70

SCREW

Sold individually.

$3.96

Freezer Door Key

$9.75

Spray Paint - 12 oz. - White

$2.70

USE WPL 3400894

$3.96

Gate Support - Right Hand

$4.11

USE WPL 4357277

$116.52

Door Gasket

This gasket is used on vertical freezers. Screws are no longer included.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake MN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 70 of 78 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

The handle on my freezer had broken.

  • Customer: Jo Anne from Schuyler NE
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 12 people found this instruction helpful
Took out the 2 screws that held the old handle in place. I then lined up the holes on the new handle and put the same screws back in being careful to put the shorter one in the bottom hole. When I had tightened the screws I put on the face plate to cover the screw heads and now my frezzer looks like new again!!!!! read more

gasket had harden. frost was building up quickly

  • Customer: LESLIE from TAPPAHANNOCK VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver
  • 8 of 11 people found this instruction helpful
the gasket peels back to reveal the approx 20 screwsholding gasket and door shelves. removed these. removed old gasket from door panel. new gasket needs to be stretched to get on door panel. align screw holes in door panel with screw holes in gasket. attached back to freezer door. this gasket did not seal securely when closing door. this gasket was ins... read more