Models > TVF12FRGW01

TVF12FRGW01 Whirlpool Freezer - Overview

Get Parts and Repair Help for TVF12FRGW01

If you know the freezer repair part you need, you can browse the list of all parts on the TVF12FRGW01, or you can search by name or part description. You can also find your part by where it is located on the TVF12FRGW01 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the TVF12FRGW01 [Viewing 4 of 4]

$15.44

Capicitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$2.70

Screw

This screw is sold individually.

$4.65

Touch-Up Paint - White

$2.70

SCREW

Sold individually.

$3.96

Freezer Door Key

$7.54

Spray Paint - 12 oz. - White

$3.82

Screw

Sold individually.

$3.82

Screw

Sold individually.

$10.18

Leveling Leg - 1 per Package

$9.23

BOLT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

My refrigerator stopped cooling and the freezer section stopped freezing

  • Customer: garth from forest lake MN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 110 of 120 people found this instruction helpful
I knew the chances of all the freon leaking out was unlikely so I looked at the wiring to the compressor and there was a capacitor and a starter/overload so i figured I would start there. I went on line and found the parts at this site and they were less than the minimum service call charge for a service tech so I figured what the heck let's give her a shot ... read more

The handle on my freezer had broken.

  • Customer: Jo Anne from Schuyler NE
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 11 of 12 people found this instruction helpful
Took out the 2 screws that held the old handle in place. I then lined up the holes on the new handle and put the same screws back in being careful to put the shorter one in the bottom hole. When I had tightened the screws I put on the face plate to cover the screw heads and now my frezzer looks like new again!!!!! read more

Scratches in Surface

  • Customer: Michelle from Richardson TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 11 of 13 people found this instruction helpful
This product comes in a bottle with a brush like Liquid Paper. It goes on incredibly easy. A second coat might be needed. I wanted to prevent rust from setting in so I covered the scratches and dings. The paint is a little brighter since my washer is 10 years old but it still looks great. read more