Models > TRS20WRHD3

TRS20WRHD3 Tappan Refrigerator - Overview

Get Parts and Repair Help for TRS20WRHD3

If you know the refrigerator repair part you need, you can browse the list of all parts on the TRS20WRHD3, or you can search by name or part description. You can also find your part by where it is located on the TRS20WRHD3 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for TRS20WRHD3 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$19.21

Defrost Timer - 60Hz 120V

This defrost timer will cycle for thirty minutes after every eight hours of run time.

$3.56

Door Shelf End Cap - Left or Right Side

This end cap can be used for the right or left side of the refrigerator door shelf or the freezer door shelf.

$3.27

Door Shelf End Cap - Left or Right Side

It can be used for either the right side or the left side of some refrigerator door shelves.

$12.91

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fahrenheit.

$25.71

Dispenser Crusher Housing

This part may look different or be a different color than the original, but will fit and function the same as the original part.

$97.27

Replacement Ice Maker

This part is the replacement heat-release ice maker unit only. This kit comes with four round female connectors at the end of the wire harness. It also comes with the adaptor that converts the harness to three round female and one round male connectors.

$119.61

Ice Maker - 115V

This ice maker makes radius cubes.

$31.00

Ice Container/Bucket

Bucket only. All other parts sold separately.

$13.93

Light Bulb

This 40 watt appliance light bulb are used for some ranges, refrigerators, and microwaves. They are sold individually.

$26.80

Drive Blade

The drive blade helps rotate out cubed or crushed ice.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Fridge got warm and freezer coils were frosted

  • Customer: Stephen from Warrington PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 154 of 171 people found this instruction helpful
Fridge is a side by side. The freezer is pretty narrow for a guy with wide shoulders.

Pulled plug.

Had to remove bottom drawers then used nut driver to remove screws closest to back wall in drawer runners. Once the back screws were removed the runners could be swung up or down out of way so back cover could be removed.

On... read more

ICE MAKER STOPPED WORKING

  • Customer: JACK from MESA AZ
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 66 of 69 people found this instruction helpful
IT WAS PRETTY STRAIGHT FORWARD. REMOVE THE TWO SCREWS THAT HOLD THE UNIT TO THE WALL OF THE FREEZER. IN MY CASE, I HAD TO USE A DIFFERENT ICE MAKER THAN WHAT CAME WITH THE FRIG. IN ORDER TO INSTALL THE REPLACEMENT UNIT THEY SENT A WIRE ADAPTOR SO IT WOULD ATTACH TO THE EXISTING WIRING. THAT TOO WAS ALL FINE AND DANDY. THE ONLY PROBLEM WAS THAT THE END O... read more

Water resevoir tank was leaking

  • Customer: Suzanne from Collinsville IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 35 of 51 people found this instruction helpful
Manufacuturer does not make the tanks any more. Had to by a replacement kit which is basically a 40 ft. plastic tube worth about $10 but they charge you upwards of $55 for it. What a RIP OFF!!! Comes with a self-tapping screw that does not self tap. After 30+ minutes of both of us trying to get the screw to self-tap, we got the drill and started the hole... read more