Models > TGF602PGW3

TGF602PGW3 Tappan Range - Overview

Get Parts and Repair Help for TGF602PGW3

If you know the range repair part you need, you can browse the list of all parts on the TGF602PGW3, or you can search by name or part description. You can also find your part by where it is located on the TGF602PGW3 by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$5.62

SCREW

$35.95

Door Hinge - Left Side

This hinge is located on left side of the oven door.

$34.04

Hinge - Right Side

$5.94

Levelling Leg with Rubber Pad

Sold Individually.

$26.13

Burner Control Knob

Sold Individually. This knob accepts a D-shaped shaft.

$3.41

CLIP

$80.68

Spark Module

A device which uses high voltage spark discharge to the spark switch to ignite gas.

$52.37

Rear Top Burner

$137.62

Gas Pressure Regulator

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

$59.64

INSERT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Springs pooped off door hinges, causing hinges to break through door face

  • Customer: Xavier from Rocky Point NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 7 of 10 people found this instruction helpful
Remove decorative side panels on stove to expose backside of hinge and springs;
remove door;
remove old hardware;
since hinge openings were bent, straighten hinge opening in oven face;
attach spring to inside of oven;
slide hinge through opening;
attach spring to hinge;
screw hinges to oven face;
repeat on other side;<... read more

the stem of the stove top burner control knob cracked

  • Customer: Andrew from Brooklyn NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 1 of 2 people found this instruction helpful
the new knob fit the stem on the burner control perfectly. However, the lettering on the knob (Lite, low, etc.)is exactly 180 degrees in the wrong orientation. So, when using the knob the user has to ignore the print and look at the other control knobs to know which direction, etc. to twist the knob. read more

Broken hinge

  • Customer: MICHAEL from MAY'S LANDING NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 1 of 3 people found this instruction helpful
Replaced same very simple. read more