Models > TGC3X4XCC2

TGC3X4XCC2 Tappan Cooktop - Overview

Get Parts and Repair Help for TGC3X4XCC2

If you know the cooktop repair part you need, you can browse the list of all parts on the TGC3X4XCC2, or you can search by name or part description. You can also find your part by where it is located on the TGC3X4XCC2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the TGC3X4XCC2 [Viewing 4 of 4]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.89

Porcelain Drip Pan

$0.43

Top Burner Mounting Screw with Washer

This is now a new zinc and black-coated screw that will resist rust and seizing.

$13.81

Surface Burner Igniter Electrode

Use this igniter with sealed burners.

$25.15

Small Burner Base with Orifice and Igniter

This part also includes 3 screws. Small burner cap is sold separately.

$37.39

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$31.02

Igniter Switch

When the gas burner valve knob is depressed and turned, this part creates a spark that lights the gas and starts the burner.

$26.59

ORIFICE

$18.64

Bushing

$137.62

Gas Pressure Regulator

***No Conversion Kit Required - Adjust On Appliance*** This valve automatically cuts off the flow of a liquid or gas when it reaches a certain pressure.

$5.79

Burner Cap - Black

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Igniter porcelain was cracked and burner would not light.

  • Customer: Rusty from Howell NJ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 27 of 37 people found this instruction helpful
un-pluged stove,removed the one screw holding the broken igniter. disconected the one wire. installed new igniter and slipped on wire. The igniter came with a new bracket, the old one rusted away which is why the old igniter broke. read more

gas ignitor continued to run after turned on or off

  • Customer: Duff from Buena Vista CO
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
Removed all of the grates, control knobs and gas diffusers. Unscrew the drip pans, two on each pan, which attach the pans to the gas supply. Raised the drip pans from the top and unplugged the ignitors from all pans. Remove the top and the rubber deflector over the ignitor switch. The ignitor switch snaps off and on. One of the seals under the drip pan was b... read more

Drip pans needed replaced

  • Customer: Myra from Moundsville WV
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 7 of 12 people found this instruction helpful
Piece of cake. Fit like a glove. Thank you read more