Models > TGA600 (P7575202W)

TGA600 (P7575202W) Amana Dryer - Overview

Get Parts and Repair Help for TGA600

If you know the dryer repair part you need, you can browse the list of all parts on the TGA600, or you can search by name or part description. You can also find your part by where it is located on the TGA600 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for TGA600 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.06

Idler Pulley Wheel with Bearing

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$4.46

Thrust Washer

$25.16

Radiant Flame Sensor

This part senses the flame for heat allowing the gas valve to open.

$2.70

Retaining Ring

Sold individually.

$11.78

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

$3.91

Single Drum Glide Felt Pad

This part is used on the front dryer drum glides.

$12.92

Door Switch Kit

This part replaces older two terminal switches.

$18.91

Blower Wheel

Part may differ in appearance, but functions same as original part.

$2.70

Screw

This screw is sold individually.

$11.02

Idler Pulley Shaft

This shaft is made to fit the center of the idler pulley wheel of your dryer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

catch mounted on door broke

  • Customer: Paul from Mt. Pleasant SC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 43 of 56 people found this instruction helpful
The door had always opened with the wrong swing and it wasn't til I needed to repair this that I noticed you could change the swing. I changed the swing of the door and then noticed that the clip was included on both sides so i did not need to repair the catch. I still have the part so when it breaks again, I can just pop it in. read more

Switch sticking in on position

  • Customer: Don from Jacksonville FL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 41 of 56 people found this instruction helpful
FIRST unplug dryer from electrical source, CAUTION, the top of this dryer does not open with clips, do not pry on top to open! On the front of the dryer look under the lower panel, and find two screws, one on the left side, and one on the right, remove these screws, and pull slightly down on panel to remove. Behind this panel find two screws holding the do... read more

GAS FLAME WOULD DROP OUT

  • Customer: FRED from BRIELLE NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 39 of 53 people found this instruction helpful
first it was a process of alimination to find out why it was dropping out. after the problem was found it was just a matter of replacing the holding coil on the gas valve.
THANK YOU
FRED KENNEY SR read more