Models > TFU09M4AW2

TFU09M4AW2 Tappan Freezer - Overview

Get Parts and Repair Help for TFU09M4AW2

If you know the freezer repair part you need, you can browse the list of all parts on the TFU09M4AW2, or you can search by name or part description. You can also find your part by where it is located on the TFU09M4AW2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your freezer. We’ve also included any installation videos we have for TFU09M4AW2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the TFU09M4AW2 [Viewing 3 of 3]

$19.35

Run Capacitor

This part is attached to the compressor. It helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

$6.68

Freezer Door Key

This metallic freezer door key is used for most upright or chest freezers.

$37.61

Door Handle

Handle insert or screws are not included.

$9.57

Handle Insert

This is NOT the handle. This is the decorative front insert.

$17.84

Door Shelf End Cap Set - Left and Right Side

$4.38

SCREW

$6.43

Single Gasket Retainer Clip

Sold Individually.

$7.25

Shelf Support

$7.36

Shelf Support

$4.75

BEARING-HINGE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Clicking sound then within a minute clicking again, not cooling.

  • Customer: Melvin from Semmes AL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 51 of 58 people found this instruction helpful
UNPLUG REFRIGERATOR. Carefully remove relay from the side of the compressor. You shouldn't need a tool to do this, if it is hard you can gently pry the edge with a flat head screw driver just to loosen. Unplug white and red wires from relay, noting that the white wire goes in the hole with a #2 stamped beside it. Shake old relay, if it rattles like a baby r... read more

The end caps of the door shelf bracket broke

  • Customer: Melvin from Manning IA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 15 of 20 people found this instruction helpful
Put the end caps on the ends of the shelf bracket and returned the bracket to the proper place in the freezer.

Just wanted to add that the service and helpfulness to get this part for a freezer that is close to 30 years old was super. After almost 30 years, this was the first thing to go wrong with this freezer. We did not expect to be able t... read more

Stopped working, cooling.

  • Customer: Jennifer from Jonestown TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 13 people found this instruction helpful
I used a small screwdriver to disconnect wires from old starter. I connected the overload and starter, two wires. I put the unit back in the keeper, plugged the unit in, turned up the thermostat and it's working beautifully. read more