TEF361ESA Tappan Range - Instructions

The video was a great help. I could have replaced the switch without watching it, but it gave me confidence that I was doing it right. Everything went just like he said it would. Burner seems to work better now and no more scary noises.

aftering watching your repair video the repair went very well we took the oven door off to make access easier. the worst part of the repair was getting the door back on.

Undo the two nut screws pulled out the element and replaced it with the new one.

Followed instructions on YouTube and Frgidaire website. It looked easy; was easier than it looked -)

Removed the oven door, the trim was already cleaned and ready for new glass. Once the new part arrived, I removed it from the shipping container, placed it in the bottom groove of the trim kit and tightened the screws. Then placed the top trim and handle assembly, in place and tightened the screws. Then placed the oven door back on stove.

Removed old element by taking out two screws at bottom rear of oven. Pulled element and wires forward from two holes and unclipped from wires. Clipped new element to wires and pushed the wires back into the holes. Then replaced the two screws. Needed flashlight so that 60+ eyes could see the screws and holes in the oven. A quick and inexpensive repair. Element was delivered very quickly.

took the two nuts off the back wall of the stove and disconnected the push on terminals. ordered by model number. replaced and reinstalled the two nuts in stove. simple as possible

replaced oven door glass

Unplugged stove. Quickly unscrewed back panel (4 screws). Popped the wires off one at a time attaching them to the new switch. Pulled the knob off the front, unscrewed screws, and put new switch in repeating previous steps in reverse. Put the panel back on, plugged it up, and pushed it back into place. Done.

It was just a matter of loosing 2 screws on baking element & pulling 2 wires off & putting back on. On the Burner I had to take 6 to 8 screws off back 4 wires off & 2 screws on fron of switch. Very Easy!

take back planel off, take wires off old element and intsall new element hookup wires, put back planel ..under one hour job

took off back cover unhooked wires. pulled out screws in the oven and removed the element. put in new element replaced screws reattached the wires in the back replace the back cover. Done

I followed the Parts Select Video that showed replacing an identical switch. Mine were another brand & style with different color wires. I took a picture of 1 to keep track of the wiring and removed it. I saw that the terminals were marked P, H1, H2, L1, & L2 so I put the wire from the same terminal onto the Parts Select switches & they work just fine now. The parts I got from you are heavier and a much better quality than the original equipment. I would also like to say that I was amazed at how fast this order was shipped, and the washer pump was a piece of cake thanks to your video.

No directions come with the parts. I used a nut driver to unhook the connections on each side. The wire was connected with a male/female small connection ( they were inside the back of the oven. I pulled each one out and had to pry them loose with a screw driver. I attached each wire and used the nutdriver to tighten them. It was easier doing the repair than writing this explanation. I am not a handy man...

Moved the stove. Used the template to position the bracket. Put the supplied screws to attach bracket to the floor. Slid stove back into place. DONE!