Models > TEF351EWC

TEF351EWC Tappan Range - Overview

Get Parts and Repair Help for TEF351EWC

If you know the range repair part you need, you can browse the list of all parts on the TEF351EWC, or you can search by name or part description. You can also find your part by where it is located on the TEF351EWC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for TEF351EWC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$23.86

Bake Element - Push On Terminals - 240V

This bake element is found on the bottom of the oven.

$3.51

Drip Bowl - 8"

$6.73

Terminal Block Kit

This surface burner terminal block kit comes with interchangeable mounting brackets, ceramic wire nuts, heat shrink protective tubing and wires.

$3.51

Chrome Drip Bowl - 6"

Sold individually.

$21.41

Infinite Burner Switch - 8" - 240V

This switch controls the stove top 8" surface burner.

$15.49

Surface Element - 8" - 220V

4 Turn.

$18.68

Surface Element - 6"

$3.51

Main Terminal Block Kit

$7.64

ANTI TIP KIT

$24.52

Infinite Burner Switch - Small Element - 240V

This switch controls the stove top surface burner.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven woudn't heat

  • Customer: David from Shawnee KS
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 564 of 574 people found this instruction helpful
1. Removed two screws, pulled out the element, voltage tested the element and determined it was an open circuit (bad element).
2. Ordered the part from partselect.com
3. Disconnected element, connected the new one, and screwed it back in. read more

Element cracked in two pieces

  • Customer: Michael from Green Bay WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 534 of 621 people found this instruction helpful
Shut off circuit breaker to stove and collected the tool from the basement. Turned on flashlight. Unscrewed the two hex nuts from the old element/back of the oven. Slid the old element prongs out of the back, exposing the connecting wires. Pulled the connecting wires off of the old element, carefully, so that the connections wouldn't come off of the w... read more

oven did not heat

  • Customer: jack from chambersburg PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 377 of 381 people found this instruction helpful
removed screws pulled element out. removed wire from old element replaced with new element.very easy read more