Models > TEC3X7XCBB

TEC3X7XCBB Tappan Cooktop - Overview

Get Parts and Repair Help for TEC3X7XCBB

If you know the cooktop repair part you need, you can browse the list of all parts on the TEC3X7XCBB, or you can search by name or part description. You can also find your part by where it is located on the TEC3X7XCBB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the TEC3X7XCBB [Viewing 4 of 4]


Surface Burner Element with Limiter - 6" - 1200W


Radiant Burner Element with Limiter - 8" - 2200W















Common Symptoms of the TEC3X7XCBB [Viewing 1 of 44]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned out burner

  • Customer: Lori from Winter Haven FL
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 31 of 40 people found this instruction helpful
First we removed two screws under the rim of the range top to open the lid. Lifted the lid and removed the screws from the bracket that holds the elements, Be careful with the clips that hold the element in, if you break them or bend them there aren't any more! Also note which holes they were in, they are marked according to the different sizes of element... read more

rf burner was not working

  • Customer: Neil from Jessup PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 25 of 33 people found this instruction helpful
First I removed 2 screws that held the stove top in place. Raised the stove top and support it. Then, I removed the hold down spring for the burner and removed three wires from the old burner. I found that the connector on the white wire was spread open too much so I crimped it closed for a better fit on the terminal. I reattached the three wires, put the ho... read more

Element would not heat up

  • Customer: Everett from Colchester CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 0 of 0 people found this instruction helpful
Removed 2 screws located underneath the front lip of the range top. Lifted range top and supported. Removed the 2 screws at either end of the support bracket. This bracket holds the elements in position. Be careful not to let the elements fall out when removing. The elements are now free to replace. Swap out the old with the new and be sure to reconnect the ... read more