Models > TDB210RFS3 > Instructions

TDB210RFS3 Tappan Dishwasher - Instructions

All installation instructions for TDB210RFS3 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the TDB210RFS3
271-285 of 323
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

need drain house

  • Customer: Wilburn from Cumming GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
Very helpful and was amazed how quickly it was delivered. Very pleased.

mouse made hole in both drain hoses

  • Customer: james from tracy city TN
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
pulled machine out removed old put on new, which were a perfect fit. and were received remarkably fast.

Soap Dispense Latch - So Easy

  • Customer: Debra from Buffalo NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
Well for a women, I found this very very easy...first shut down the power in the house! Unscrew the 2 small screws on the inside of the door panel and the front panel will drop off, unscrew the 6 small screws holding the dispenser in place, unplug the 2 small wires, remove old one, pop in the new dispenser, screw back in, plug in the two wires, put the door back together and that's it!! I turned the power back on and did a load of dishes, perfect...worked like a charm.

Upper wash arm not working. Not getting proper water fill level.

  • Customer: jens from west lafayette IN
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers, Wrench set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Disconnected washer & replaced water inlet valve & supply hose. Releveled washer.

No water

  • Customer: Bret R. from Angola IN
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Wrench set, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Tested main water supply first and it checked out, next thing was the valve got a new one took old one off, flushed the line a few times to get dirty deposited water out, stuck the new inlet valve on and ran the dish washer and it worked, really a pretty easy thing to do anybody can do it and it will save you a couple hundred bucks in the repair mans labor and his cost for parts, deffinetly a must do yourself job. Got my part in two days from when I ordered it.

DOOR LEAKING

  • Customer: willis w from broomes island MD
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 0 of 0 people found this instruction helpful
ALL I HAVE TO SAY IS PAETS SELECT IS THE BEST COMPANY I HAVE DELT WITH IN THE LAST 20 YEARS

the tub was leaking at the right front corner

  • Customer: Raymond from El Paso TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
just pushed it into the crevice with my thumb

Door leaked at the bottom corners

  • Customer: Jason from Ferndale WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Pull the old door seal down and out starting at one end. Push the new seal back in, noting the small notch location. Done!

NO PROBLAMS

  • Customer: michael from prestonsburg KY
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Wrench set
  • 0 of 0 people found this instruction helpful
IT WAS ONE OF MOST EASY FIX I DONE, TOOK BOTTOM OFF UNPLUG WIRES AND UNSCREW TWO NUTS, IT CAME RIGHT OUT INSTALL NEW ONE TWO NUTS AND WIRES, CHECK FOR LEAKS.IT THAT EASY,PART FIT EXACT.

Leak at bottom of door

  • Customer: Dunstan from Port St.. Lucie FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Remove old gasket from tub, soak new gasket in hot water for a few minutes then install starting from center top of tub, when done installing close door for 24 hours, then try to see if leak fixed.

Part was damaged

  • Customer: Adrian from Ridgefield CT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Removed old part and replaced it with new part.

Broken heating element brass nut

  • Customer: William E from High Point NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Wrench(Adjustable)
  • 0 of 0 people found this instruction helpful
Ditto the other comments. Easy, great savings. Perfect. Thank you!

When Dishwasher ran water found on floor

  • Customer: Patricia from Gassville AR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I removed the old bottom gasket with my hand & replaced the new one the same way. It was very easy.

Drain Pump failed to drain.

  • Customer: Mark from Belfair WA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
I Removed the pump and took it apart. Noticed the impeller was dislodged from the shaft. Only way to fix this was to purchase a new pump. After receiving the new one and verifying its the correct pump, I installed it and ran the washer through a complete cycle. Test complete and I am back in business. Thank you for having the schematics of the dishwasher available, an easy process for purchasing the part and a wide variety correct parts.

BROKEN WHEELS ON LOWER DISH RACK

  • Customer: Barbara from Highland Park IL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
JUST A LITTLR SNAP IN THE RIGHT PLACE AND PERFECTION!
All Instructions for the TDB210RFS3
271-285 of 323