TDB210RFS1 Tappan Dishwasher - Instructions

merely snapped the part on

At 1st gasket kept going in to far, but after a few tries an my wifes help it went in. I had trouble with the adjustable legs as the floor was tiled an rasid up, but all in all everything went good. Ran it a few times on rinse. We're ready to go. Richard

Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.

Turn the water off to the dishwasher. Loosen water supply connector w/ crescent or sized wrench. Remove bracket srews from water inlet. Remove spring clip from discharge hose, remove hose from discharge nipple. Replace with new part in reverse order.

pulled the old gaskets out, put the new ones in. Just like that. No tools, nothing. I would compare it in difficulty to the process of paying for gas at the pump and then filling your car up.

The 'kick plate' had to be removed, and the feet had to be raised to lift the unit over the floor. the old spring could not be found, and while lying on the floor my husband had to 'feel' for the attatchments to hook up the new spring. The unit was then pushed back and the legs dropped and the unit attatched to the counter. All fixed - - thank you PartSelect for having the right spring.

pull out the old gasket, the right side has a notch to fit the new one. insert until gasket won't go farther.

Repair was easy, except had to run to Home Depot to buy a special screw driver to take the handle off. Once this was purchased the repair was fast and simple.

We read how others did the repair and my husband had no problem changing it.. . I have a daycare and he had it fixed in a few minute after the kids had lunch and had it in before I could get them all laid down for nap. . . he took off the front door, took ooff the pkug in to the dispenser and took it out, then put the new one in, and hooked up the plug in and put the front cover back on, and it works great!! My dishwasher hasn't worked this good in a long time. I am swo glad I fo9und this web site. Sharon-Indiana

Both heating element brass nuts had a split in them. They had fallen off the heating element and were hanging on the electrical wires. I removed the wires from the heating element and removed the brass nuts from the wires. I then screwed the new nuts on the heating element and reattached the wires. problem solved. I want to thank you for having the parts I needed as Sears had discontinued them for this Kenmore appliance.

Installed New rollers onto bottom rack. Part order & delivery were top notch from Partselect. Will definitely order from them again.

Couldn't have asked for an easier fix, directions were superb, ship time - unbelievably fast and above all, I saved almost two hundred dollars by not having a certified repair person come out to my home. Thank you Partselect!

my husband did the repair. he followed the instructions how to put it in. very easy. solved the problem of leakage.

After watching a wash cycle with the front cover off, I noticed water coming out from the bottom of the pan, under the Gasket. Pulled the gasket down out of the slit and reinstalled the new one exactly as the old one came off, with the wiper angled the correct direction.

Removed front panel and eased out screws holding the dishwasher in place. Lowered the door and removed old springs. Replaced the springs and sit the unit back in place. When they are this old it is best to replace both springs. Rated easy...,