Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
Below is a list of all parts for the Jenn-Air Trash Compactor TC507S0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.
This part is used to support the hinge.
No longer available in Almond.
Appliance spray paint is a great way to cover up any chips and scratches that have appeared on your appliances. Instead of replacing the part entirely, this is an easy fix. This is also a great way to give a fresh new look to any handles or areas that have discoloring due to wear. Make sure to clean the area before you begin and wear a protective mask for safety. Give the can a good shake and spray a few inches away from the surface. Apply the paint until the area is fully covered as desired. Wait until the paint has dried before using the appliance.
Includes everything pictured above.
This screw is sold individually.
Size: 8-32 x 1/4 inch.
This drive motor is for trash compactors. The drive motor turns the gears and chain that raise and lower the compactor ram. If your trash compactor will not start or will not stay on during the compaction cycle, you may have a defective drive motor. The start or run switch is used to supply power to the motor to initiate the compaction cycle. If the windings in the motor are open or if the motor centrifugal switch is open, the unit will not start. To check for a defective motor, you will need to remove the unit from the cabinets and disconnect the power.
This part is located at the bottom of your appliance.
Silicone rubber adhesive is a high temperature adhesive that is used for gaskets on dryers and felt seals. It is used on many different appliances for many different application reasons. This silicone paste creates a waterproof seal between components. This product is a 2 oz. tube. Unplug your appliance if you will be working on any internal workings and applying this sealant. Wear gloves to protect your hand from accidently applying sealant to your skin. The surface must be clean, dry, and free from oil and grease. Coat one surface and let it dry for at least one minute and then bond.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.