Models > TC4700XYP0

TC4700XYP0 Whirlpool Trash Compactor - Overview

Get Parts and Repair Help for TC4700XYP0

If you know the trash compactor repair part you need, you can browse the list of all parts on the TC4700XYP0, or you can search by name or part description. You can also find your part by where it is located on the TC4700XYP0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your trash compactor. We’ve also included any installation videos we have for TC4700XYP0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$16.38

15" Compactor Bags - 15 Pack

These bags will fit most 15" rectangular compactors.

$23.66

Drive Gear Kit

This kit is used for trash compactors. It includes both gears, pin spring, C-ring, ram stop, and ram cam.

$2.70

Screw

This screw is sold individually.

$1.95

Foot, Front - Single

Sold Individually.

$4.95

Touch-Up Paint - White

$45.45

Rotary Switch Kit

This kit comes an on-off rotary switch, and two chrome knobs.

$26.93

Directional Switch

$11.30

15" Compactor Bag Carrier with Easy Grip Handles

Compactor bags are sold separately.

$21.78

Power Nut

$37.87

Foot Pedal

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Trash Compactor ram wouldn't lower

  • Customer: Scott from Indianapolis IN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 16 of 17 people found this instruction helpful
I pulled the trash compactor out from under the counter.

I took out the four screws that kept the top cover in place to expose the ram.

The gear shafts were turning but the ram would not lower, at first I though the ram drive bolts were stripped and it wouldn't engage the shaft. Then I realized there was a mechanical directional\limit s... read more

Compactor motor kept running after cycle ran, making alot of noise and unit jumping around.

  • Customer: Keith from Keller TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 13 of 14 people found this instruction helpful
Pulled the Compactor from underneath cabinet, unplugged power. Removed the top plate off compactor to expose the crush piston. Removed the front control panel by removing two phillips screws, wiring and directional (limit) switch is now exposed. Removed the two screws securing switch, removed wiring one wire at a time and replaced on new switch in same posit... read more

Compactor out of line and would not shut off.

  • Customer: Janet W. from Shreveport LA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 13 of 15 people found this instruction helpful
Pulled compactor out on a piece of cardboard. Used socket set to take top off and evaluate the problem. Power nut was not holding on one side. We ordered two power nuts. Decided to repair only the unlevel side. Fast and easy and cheaper than a new compactor. Whirlpool compactor is 28 years old and working like a charm. Thanks for the diagram an... read more