Models > TAA800 (P7575103W)

TAA800 (P7575103W) Amana Washer - Overview

Get Parts and Repair Help for TAA800

If you know the washer repair part you need, you can browse the list of all parts on the TAA800, or you can search by name or part description. You can also find your part by where it is located on the TAA800 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for TAA800 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Hose Clamp

$2.70

Screw

This screw is sold individually.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Spring Retaining Clip

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.70

SCREW

Sold Individually.

$26.45

Main Tub Bearing Assembly

$3.82

Screw

This screw is sold individually.

$2.70

Inlet Hose Gasket

$4.46

Rubber Foot Pad

This pad is used for the levelling legs of many washing machines.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Bearing went out causing lots of noise.

  • Customer: mike from hull IA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 16 of 18 people found this instruction helpful
This is not a bad repair, but give yourself some time. I did not have to take the tranny and motor out, but the inner and outer tub and all related parts had to come out, along with the outer tub base. If you are replacing the tub bearing, you HAVE to order the seal kit. Don't try to skimp like I did, since you will need the seal kit as this is what causes t... read more

Brake pads were worn out

  • Customer: Stephen from Kittanning PA
  • Difficulty: Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Wrench set
  • 7 of 8 people found this instruction helpful
Unplug the washer
Took off the front with nut driver to two fasteners at the bottom.
Took off two tub springs using channel lock pliers.
Tipped the tub back for more hand room.
Took brake bolts off with box end wrench.
Put Screw driver above brake clamps and pried down to make the old brake pads drop down below the seats and then tak... read more

Water leaking when water level is set above medium. Wash tub spinning when during agitation cycle.

  • Customer: Martin from Grayslake IL
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Wrench set
  • 5 of 5 people found this instruction helpful
Three brake pads are located just above the drive pulley and space symmetrically around the brake wheel. Remove the one screw per brake, slide brake out of brake wheel and replace with new brake. Apply silicone grease to new brakes before installing. Tools: 5/16 boxed end wrench. read more