Models > SWX703HS1

SWX703HS1 Westinghouse Washer - Overview

Get Parts and Repair Help for SWX703HS1

If you know the washer repair part you need, you can browse the list of all parts on the SWX703HS1, or you can search by name or part description. You can also find your part by where it is located on the SWX703HS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for SWX703HS1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$11.41

Drive V-Belt

This belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$108.17

Drain Pump - 120V 60 Hz

The pump is what your washer uses to remove the water from the tub. This part is the pump and motor assembly which includes the red flapper to prevent drain back flow.

$17.91

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$5.50

SCREW

$46.50

Tub Seal Assembly

This seal helps prevent any leaking around the transmission of washing machines.

$4.62

Leveling Leg

$8.75

Tension Idler Pulley

This idler arm assembly comes with the pulley wheel.

$24.48

Selector Knob

This white knob accepts a D-shaped shaft.

$45.23

Lid Lock Switch

$39.29

Drain Hose

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

replace broken drive belt

  • Customer: rodney from fairfield bay AR
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 155 of 174 people found this instruction helpful
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run... read more

would't spin all water out or rinse out clothes

  • Customer: kenneth from willard OH
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 88 of 106 people found this instruction helpful
uplugged washer took front off washer 2 screws pryed up top pump was mounted with 2 screws and 2 wires took off found change in pump and the fins to pump worn off ordered part off line the wait for part was longer than the amount of time to fix problem and cost of part saved me about $25-35 if I was to buy local worth wait save money and fix problem washes l... read more

After a full cycle the washer would not drain the water

  • Customer: sara from North Miami FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 41 of 43 people found this instruction helpful
After reading the possiblilities of problem, I determined that the drain pump was not working; therefore I ordered a new one. When I opened the washer to replace the part, I found out that the pump was working but the filter was stuffed with pieces of rubber that came out from a rug I washed. Once all the stuff was removed, the washer worked just fine. PartS... read more