Models > SWSG1031HS0

SWSG1031HS0 Westinghouse Washer / Dryer Combo - Overview

Get Parts and Repair Help for SWSG1031HS0

If you know the washer / dryer combo repair part you need, you can browse the list of all parts on the SWSG1031HS0, or you can search by name or part description. You can also find your part by where it is located on the SWSG1031HS0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer / dryer combo. We’ve also included any installation videos we have for SWSG1031HS0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$8.16

Rotary Knob

This knob includes tension spring clip and will accept a D-shaped shaft. Sold individually.

$19.45

Drum Glide - White

Appliance requires 2 .Sold individually.

$2.77

Drum Support Bearing

$12.46

Drive V-Belt

This belt is made to slip on the motor pulley to bring the basket up to the speed required and this makes the belt get wear and tear.

$23.71

Door Catch

$19.41

Lint Filter

This filter collects lint as it passes through the dryer vent.

$12.61

Lower Front Felt Seal with Adhesive

$10.91

Multi-Rib Drum Belt

$18.71

'M' Series Ignition Coil Kit

This ignition coil kit contains two coils. One is a two wire secondary coil, while the other is a three wire booster coil. Both should be used together in your gas clothes dryer.

$106.03

Drain Pump - 120V 60 Hz

The pump is what your washer uses to remove the water from the tub. This part is the pump and motor assembly which includes the red flapper to prevent drain back flow.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Knob's plastic hub broken

  • Customer: Clint from Mobile AL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 461 of 462 people found this instruction helpful
selected correct replacement knob. used small screw driver to remove small black metal sleeve from switch shaft. (had left that in place to be able to turn on dryer with needle nose pliers while waiting on knob). aligned flat of new knob with switch shaft and gently pressed into place. read more

Dryer start knob broke

  • Customer: Cynthia from Athens GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 367 of 370 people found this instruction helpful
Googled dryer start knob, Part Select was second site I clicked on, found within 1 min, part was inexpensive, easy to order, arrived quickly and fit perfectly. Excellent online ordering experience. read more

replace broken drive belt

  • Customer: rodney from fairfield bay AR
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 129 of 146 people found this instruction helpful
carefully pry up on front washer top to release plastic keeper pins,remove 2 phillips screws from beneath lower front washer panel,slightly lift upward on panel to release.remove old broken belt,push new belt beneath large tub pulley,put belt on small motor pulley,push back belt tension /idler arm,start belt on large tub pulley,turn tub pulley by hand to run... read more