This wheel is a dishwasher rack wheel designed for the upper rack of your appliance. The roller wheel is approximately 1.25 inches in diameters and includes the brushing you need for installation. It ...
$10.00
In Stock
Order within the next 8 hrs and your part ships today!
This dishrack wheel is designed for use on the lower rack of your dishwasher, it allows the rack to roll in and out of your appliance with ease. This roller wheel includes the locking clip required fo...
$18.55
In Stock
Order within the next 8 hrs and your part ships today!
This is a replacement water inlet valve for your washer. The water inlet valve in your washer connects to the water source and solenoid wires, and ensures the tub has the right amount of water enterin...
$62.65
In Stock
Order within the next 8 hrs and your part ships today!
A holder is used in dishwashers, it is known as the dishrack stop kit. This kit comes with both the front and the rear stop, these parts are installed at either end of the rails that the upper rack sl...
$12.03
In Stock
Order within the next 8 hrs and your part ships today!
This part is the replacement screw for your washer. The head is approximately 1/4 inch in diameter and the screw is approximately 3/4 inch in length. It is made of metal and is sold individually. This...
$7.70
In Stock
Order within the next 8 hrs and your part ships today!
We let this go for a shameful amount of time before I decided I could probably fix it. The roller broke so you could only pull it out about halfway or it would come off the track. I looked up the part, and bought it. Actually bought two in case it happened again. When I arrived I looked at how it was put together on the other side and t
... Read morehen just basically pushed it onto the rod and it was fixed. I am ashamed it took so long to do it. Never be afraid to try it yourself. It was a total of $10 shipped to fix it.
Remove the dishwasher from under the counter. Remove door springs. On the inside of the lip of the door remove the 6 screws that hold the outer door panel on, and remove panel. this will expose hinge screws. Remove the two screws per side holding the inner door to the hinge assembly. Take pictures of the way the gasket's grey plastic end
... Read morecap assembles between the inner door frame and the hinge, and remove the inner door. The old gasket has a channel lip that sits on the plastic edge of the washer tub, pull it off this lip and discard. Install new gasket and put it all back together! Use this opportunity to clean the gunk out of the upper door seals.
It was necessary to pull the dish washer to access the valve located on the lower left front of machine. Some difficulty in disconnecting water inlet and outlet hoses to valve since spring clips used to secure hoses. Tight spaces to remove the old valve and install new valve. Used screw type hose clamp on reinstall in lieu of spring cl
... Read moreips. May have been easier had I had the special pliers used to remove and install spring type clips. Saved a minimum of $100 for service call.
