Models > SCS3017RT04

SCS3017RT04 Whirlpool Cooktop - Overview

Get Parts and Repair Help for SCS3017RT04

If you know the cooktop repair part you need, you can browse the list of all parts on the SCS3017RT04, or you can search by name or part description. You can also find your part by where it is located on the SCS3017RT04 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Igniter Screw

This screw is sold individually.

$3.83

SCREW

$8.07

Grate Feet - Pkg 4

$16.73

Surface Igniter

Also known as Spark Electrode. This part helps your burner ignite and produce flame.

$32.03

Burner Cap - Left Rear/Right Front - Coal Matte Black

$38.12

Natural Gas To Liquid Propane Gas Conversion Kit

$69.52

Pressure Regulator

This valve will automatically cut off the flow of gas when it reaches a certain pressure.

$70.13

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$19.99

BURNR-HEAD

$43.86

Burner Cap - Right Rear - Coal Matte Black

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Top burners would not light. No "clicking" .

  • Customer: Carolyn from Bellingham MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 14 people found this instruction helpful
My husband and I replaced the igniter module, following directions we found online. We removed the old one, replaced it with the new one, and thankfully everything is working great! read more

Igniter problem on one gas burner

  • Customer: Roland from Houston TX
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 9 of 9 people found this instruction helpful
I had to remove the two separate components of the gas burner unit, each had two screws. I lifted then tilted the lower portion of the burner unit to allow access to the underside of the igniter. I removed the wire and then with an offset screwdriver I removed the single screw that held the igniter in place. I reversed the steps to install the replacement,... read more

gas burners would not automatically light when gas turned on

  • Customer: MICHAEL from LONGVIEW TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 6 of 7 people found this instruction helpful
I went online and discovered the repair method and schematic of the range. I removed the spark module after first removing the upper rear panel cover and replaced with the new part module ordered from your company and now the spark module operates all the gas elements when they are turned on thus lighting the gas burners. My mother in law was thrilled, as sh... read more