Models > SC8640EEW0

SC8640EEW0 KitchenAid Refrigerator - Overview

Get Parts and Repair Help for SC8640EEW0

If you know the refrigerator repair part you need, you can browse the list of all parts on the SC8640EEW0, or you can search by name or part description. You can also find your part by where it is located on the SC8640EEW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the SC8640EEW0 [Viewing 2 of 2]

$16.02

Top Burner Spark Ignition Electrode with Retaining Clip

$70.13

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$69.52

Pressure Regulator

This valve will automatically cut off the flow of gas when it reaches a certain pressure.

$17.11

KNOB

$3.84

SCREW

$28.36

Gas Valve/Switch Seal Cover

Part is located on top of the igniter switch that's next to the gas valve. Helps regulate gas flow and the amount of normal leakage that may occur.

$13.41

Surface Burner Knob

Sold individually.

$3.84

SCREW

$25.51

HARDWARE

$4.60

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

There was a crack in the porcelain not letting it spark

  • Customer: Billy from Martinsville IN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 16 of 20 people found this instruction helpful
I used a screwdriver to pry the electrode assy. out of the burner. then disconnected the wire.
Then just connected the new electrode and place the assy, in the burner. read more

Top burners would not light. No "clicking" .

  • Customer: Carolyn from Bellingham MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 11 of 14 people found this instruction helpful
My husband and I replaced the igniter module, following directions we found online. We removed the old one, replaced it with the new one, and thankfully everything is working great! read more

gas burners would not automatically light when gas turned on

  • Customer: MICHAEL from LONGVIEW TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 7 of 8 people found this instruction helpful
I went online and discovered the repair method and schematic of the range. I removed the spark module after first removing the upper rear panel cover and replaced with the new part module ordered from your company and now the spark module operates all the gas elements when they are turned on thus lighting the gas burners. My mother in law was thrilled, as sh... read more