Models > SB160PEXQ1

SB160PEXQ1 Whirlpool Oven - Overview

Get Parts and Repair Help for SB160PEXQ1

If you know the oven repair part you need, you can browse the list of all parts on the SB160PEXQ1, or you can search by name or part description. You can also find your part by where it is located on the SB160PEXQ1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your oven. We’ve also included any installation videos we have for SB160PEXQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the SB160PEXQ1 [Viewing 4 of 4]

$2.52

Light Bulb - 40W

Sold individually.

$2.70

Cover Screw

Sold individually.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$54.80

Flat Style Oven Igniter

This igniter is lighted by the spark switch to produce a flame to ignite the oven.

$69.52

Pressure Regulator

This valve will automatically cut off the flow of gas when it reaches a certain pressure.

$64.00

Oven Igniter

$4.60

SCREW

$46.42

BUTTN-PUSH

SCREW, 8-22 ***

$480.30

CNTRL-ELEC

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

ignitor glowed but did not ignite

  • Customer: james from long beach NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 14 of 22 people found this instruction helpful
took oven base plate out. diconnected ignitor , put new clips on neutral wire as per instructions, inserted new ignitor, put everything back, worked ok. read more

Oven wouldn't heat,no gas smell,no glowing ignitor

  • Customer: todd from minneapolis MN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 5 of 6 people found this instruction helpful
Remove diffusers in bottom of oven,remove two screws that hold ignitor in place.Pull oven out, to access back of oven,remove three screws holding vented panel in place.Remove panel,find wires coming from ignitor,pull connectors apart and remove old ignitor.Install new ignitor in reverse order.Too bad for my wife it works fine now,she had a new oven/range pi... read more

Replacing the bulb in the freezer side

  • Customer: Yafa (and David) from Bothell WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 4 of 5 people found this instruction helpful
Removed the ice brucket,
Removed the light shield by releasing one screw using a nutdriver.
Replacing the bulb and reinstalled the light shield.

Your web site is one of the best and most helpfull service sites I ever used. Just wish that in the future you will ship parts overseas. read more