Quick Question!

Have you ever purchased from PartSelect.com before?

Models > SAV571EEWW

SAV571EEWW Maytag Washer - Overview

Get Parts and Repair Help for SAV571EEWW

If you know the washer repair part you need, you can browse the list of all parts on the SAV571EEWW, or you can search by name or part description. You can also find your part by where it is located on the SAV571EEWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for SAV571EEWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$10.35

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

Drain Pump

This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.

$27.04

Brake Pad Kit

This brake pad kit contains three brake pads and six installation screws. Helps to bring a rotating cycle to a stop.

$105.55

Triple Lip Seal and Bearing Kit

Please check your model# to verify this is correct for your appliance.

Non-Adjustable Buzzer

$19.22

Standpipe Adapter

This part helps stop the washer from overflowing.

$126.38

Triple Lip Seal and Hub Kit

NOTE: Before ordering, please make sure this is the correct kit for your appliances Model#.

Plastic Washer

This washer is located between the brake and transmission drive pulley.

$4.79

SPRING- CO

$28.58

Friction Ring

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Spin cycle sounded like freight train

  • Customer: Mike from Houston, TX
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Socket set
  • 78 of 85 people found this instruction helpful
Spin cycle sounded like freight train, bad bearing, apparently they all fail the same way, this revised parts kit should prevent premature failure in future.

The following is easy for an experienced mechanic of any type, fully doable by an accomplished DYI'er, between this writeup and the kit instructions (which I do not fully follow) you should b... read more

tub seal/bearing failed due to dirt

  • Customer: John from Salford, PA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set
  • 48 of 58 people found this instruction helpful
First removed the front panels and tilted the top back.Disconnected the electrical connector to the motor,removed the cabinet base screws and slid the entire cabinet away from the interior after disconnecting the clear tube and the water feed to the panel.removed bolt inside agitator and remove agitator.removed the plastic hold down center nut with channel l... read more

Washer made loud noise on spin only

  • Customer: Donald from Glassboro, NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable), Wrench set
  • 45 of 58 people found this instruction helpful
Removed agitator, inner and outer tub, balance springs, motor assembly,transmission to get to bearing and seal in tub bottom. read more