Models > SAV4655AWW

SAV4655AWW Maytag Washer - Overview

Get Parts and Repair Help for SAV4655AWW

If you know the washer repair part you need, you can browse the list of all parts on the SAV4655AWW, or you can search by name or part description. You can also find your part by where it is located on the SAV4655AWW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for SAV4655AWW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.46

Thrust Washer

$2.70

Retaining Ring

Sold individually.

$51.93

Pump

This pump is attached to the motor and helps expel water from the washing machine. It is activated after the spin speed is maintained for a specific period of time.

$3.76

Adjustable Levelling Leg

Sold Individually. This adjustable leveling leg comes with a stop nut.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$18.77

Idler Pulley Wheel

This wheel has a center metallic bearing. A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$2.03

Lid Hinge Mounting Screw

Sold individually.

$2.70

Hose Clamp

This hose clamp is sold individually.

$20.64

Drain Hose with Rubber Elbow

This hose attaches to the pump to help remove the water out of the washer.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Spin cycle sounded like freight train

  • Customer: Mike from Houston TX
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Socket set
  • 51 of 55 people found this instruction helpful
Spin cycle sounded like freight train, bad bearing, apparently they all fail the same way, this revised parts kit should prevent premature failure in future.

The following is easy for an experienced mechanic of any type, fully doable by an accomplished DYI'er, between this writeup and the kit instructions (which I do not fully follow) you should b... read more

Washer made loud noise on spin only

  • Customer: Donald from Glassboro NJ
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 42 of 52 people found this instruction helpful
Removed agitator, inner and outer tub, balance springs, motor assembly,transmission to get to bearing and seal in tub bottom. read more

Maytag Washer Leaks, Noisy

  • Customer: RAYMUND from WEST COVINA CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers, Socket set, Wrench(Adjustable)
  • 29 of 34 people found this instruction helpful
1. I unplugged the machine. Using a socket wrench set, I removed the washer housing (bottom, front and sides) and flipped over the top to its service position. This exposes all the inner parts of the washer.
2. I pulled out the softener cup, unbolted the auger using a socket wrench with a long adaptor. I then pulled out the auger, exposing the "Seal Nut... read more