Models > S3200Y2WW

S3200Y2WW General Electric Washer - Overview

Get Parts and Repair Help for S3200Y2WW

If you know the washer repair part you need, you can browse the list of all parts on the S3200Y2WW, or you can search by name or part description. You can also find your part by where it is located on the S3200Y2WW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for S3200Y2WW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.71

Tub Dampening Strap

Appliance would take 4 straps. It is recommended to replace all 4 at the same time. They keep the tub in the center of the cabinet. Sold individually.

$5.93

Agitator Coupling Kit

Washing machine agitator drive bell with bolt. It connects the transmission drive shaft to the agitator base. *NOTE: Hold down bolt not sold separately.

$9.75

Drain Hose Extension - 4 1/2' Long

$3.27

Timer Knob Clip

$40.51

Dual Water Inlet Valve

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount o...

$6.62

Knob and Clip

$3.00

Drain Hose Clip

This clip holds the drain hose to the back of the washer.

$53.39

PUMP

$5.89

V-Style Drive Belt

$37.23

Dual Action Agitator

This does not come with the fabric dispenser - must order separately or use original part.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

One of eight clips broke off of the agitator assy allowing the assembly to come lose on heavy loads.

  • Customer: Paul from Carneys Point NJ
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 491 of 496 people found this instruction helpful
I replaced the coupling by only having to remove one bolt with a socket wrench. Once replaced I installed the new assy over the coupling making sure ro align the splines then pushing down until the assy snapped into place. Easy. read more

Agitator would not move during wash cycle

  • Customer: Mark from Lexington KY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Socket set
  • 181 of 210 people found this instruction helpful
I placed both hands under the agitator 180 degrees apart, gave a quick jerk, and seperated the agitator from the coupling. With the agitator removed, use a socket and ratchet to remove the bolt holding the coupling to the spline. Remove the old coupling and slide the new one over the spline. Lightly tap on the coupling if necessary. Insert the bolt with ... read more

Washing Machine was not draining water from tub.

  • Customer: Gerald from Midlothian VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers
  • 151 of 160 people found this instruction helpful
1. Drained the wash tub by taking the drain hose from the back of the washing machine and dropping it below the tub - water flowed out of hose a lot easier than trying to suck water out of tub using a pump (tried this on the first time I tried to fix washer). (Washing machine on 2nd floor of house and didn't want water running on floor)
2. Removed the... read more