Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RVM225BL02

RVM225BL02 Hotpoint Microwave - Overview

Get Parts and Repair Help for RVM225BL02

If you know the microwave repair part you need, you can browse the list of all parts on the RVM225BL02, or you can search by name or part description. You can also find your part by where it is located on the RVM225BL02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your microwave. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RVM225BL02

[Viewing 2 of 2]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$6.98

Light Bulb - 40W 130V

This light bulb is a 40 watt, 130-volt clear appliance light bulb that is manufactured to fit microwaves with small-base light bulb sockets. The light bulb illuminates the inside o...

$13.05

Light Socket - 250V 75W

This is a light bulb socket that is manufactured to fit a microwave appliance. The socket is meant to fit small-base light bulbs. The light bulb is not included with this part, so consider ordering the light bulb if necessary. You may need to replace this part if the existing socket is broken, cracked, or if light bulb is not turning on, and a new light bulb does not work. This is an electrical part so please be sure to disconnect power to your appliance before repair.

$21.50

Secondary Door Switch

The secondary door switch is a simple on/off mechanism that stops the microwave from operating when the door is open. The switch monitors the door latch position, and communicates ...

$19.78

Monitor Door Switch

Unplug your microwave before attempting this repair. You will need to remove the grill, which is held into place by two screws at the top of the grill (open your microwave door before doing this). Remove the grill. Remove the screw on the left holding the control panel in place. Loosen the screw behind the panel. You should now be able to lift the panel up and pull forward to detach. You will find the door switch by removing the screws to detach the switch assembly. Press on the release tab to remove the middle switch. Disconnect the wire connector to release the old switch.

$2.56

Grille Screw

$22.20

Hood Damper Assembly

$35.64

Grease Filter

$25.85

Thermostat Cut-Out

Also known as Thermostat or Humidity Sensor for Fault Code.

$69.14

High Voltage Diode

This diode has a 1/4" female connection and an eyelet.

$18.16

Vent Thermostat

The thermostat opens and closes if it gets too hot to run the vent fan.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The handle broke.

  • Customer: Mary-Ann De Lancey from Keene, NH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 461 of 463 people found this instruction helpful
One screw would not come out cleanly as the plastic housing from the broken handle had to fished out of the hole. Using pliers to assist with that, once the old plastic was removed, the new part inserted into the hole and using the same screws, I attached the new handle in probably less than 5 minutes. I was extremely pleased that the new handle arrived in m... read more

The handle came off. The door handle screws broke

  • Customer: Ray from Sugar Land, TX
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 440 of 518 people found this instruction helpful
Easy replacement.!I used the tip of the screw driver to remove all the broken parts from the microwave. Cleaned the screw path and screwed the nuts into the handle. read more

light worked, timer and control pad worked, but no turntable, no heat, no noises of any sort, just didn't start up

  • Customer: Marla from Arlington, TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 217 of 247 people found this instruction helpful
Noted on partselect.com that someone else with this problem, found it to be secondary door switch. There are three door switches in this model, but online info noted that one of the three might feel "soft" (in my case, one switch clicked in a rather "jiggly" way, the other two were strong decisive clicks.) To access the door switches on this model was the ... read more