Models > RUD3000DB2 > Instructions

RUD3000DB2 Roper Dishwasher - Instructions

All installation instructions for RUD3000DB2 parts

These instructions have been submitted by other PartSelect customers and can help guide you through the dishwasher repair with useful information like difficulty of repair, length of repair, tools needed, and more.

All Instructions for the RUD3000DB2
136-143 of 143
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

QUICK AND EASY

  • Customer: STEVE from WHITE PINE TN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
OPEN BOX, REMOVE REPLACEMENT PART, 5 MINUTES LATER ITS DONE. MOST OF THAT 5 MINUTES WAS CLEANING ON THE DISHWASHER. THANKS.

Not draining completely

  • Customer: Sallie from Ahwahnee CA
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Unplug dishwasher from electrical, water supply and drain hose. Pull dishwasher out from under cabinet. Unscrew water whirler from inside washer, then remove motor. Remove black boot from motor. Unscrew keeper from impellor housing. And you are there! Pull impellor off motor shaft. Replace seal first, then replace impellor. So easy this girl did it. But, this girl also does small engine repair!

The soap dispenser lid spring was broken.

  • Customer: craig from eighty four PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 0 of 0 people found this instruction helpful
I watched the video, which was very good, and did the repair. It took about 10 minutes. Most of that was watching the video. EXCELLENT VIDEO!

Heating element would not heat

  • Customer: Jim from Republic MO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
I watched the video, read all the post, they all said change the heater. So I did. Only there is a little fuse at the back of the unit that also goes bad and that was my issue. Have it ordered and will be going soon. That said, Part Select made finding and getting my parts a breeze!

Water leaking from door

  • Customer: Kenneth from East Providence RI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
Just followed the online instructions. I used white vinegar to clean any residue first. So easy.

water leaking from bottom of door

  • Customer: Mary Ann from Menahga MN
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
removed the 2 water deflector and slipped the new ones in , in place.. very easy to do but it didn't seem to stop the leak so ordered the door gasket

The part had broken, causing the upper rack to droop.

  • Customer: Jan from Bend OR
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
The repair was so easy it was ridiculous...simply removed the end cap on the front of the roller assembly, took old one out, added new one and then put the end cap back on! Done in about 2 minutes!

Leaking where motor drive shaft enters pump

  • Customer: Steven from Woodstock IL
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 0 of 0 people found this instruction helpful
Remove lower rack in dishwasher, remove dishwasher, lay dishwasher on it's back, remove and replace motor and pump.Install new impellar with new seal. reconnect water, electrical and drain hose. Easy Peasy
All Instructions for the RUD3000DB2
136-143 of 143