Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RTW4640YQ0 > Parts

RTW4640YQ0 Roper Washer - Parts

All parts for the Roper Washer RTW4640YQ0

Below is a list of all parts for the Roper Washer RTW4640YQ0. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the RTW4640YQ0
1-14 of 110
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.05

Lid Latch Assembly

The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the wa...

$67.04

Water Inlet and Valve Assembly

This water inlet valve attaches the water lines to the back of your appliance. The attaching solenoids on the valve open and close according to the desired temperature, or amount of water needed.

$22.66

Drive Belt

The main drive belt is designed to ride on the pulley until the basket gets up to speed.

$4.63

SPRING

Tub centering spring - Included 2 springs

$64.69

Suspension Rod Kit

This kit includes 4 suspension rods.

$33.72

Clutch Assembly

$51.53

Shift Actuator - 120V 60Hz

This part changes the transmission from agitation to spin mode.

$25.19

Strike

$3.02

Lid Hinge Mounting Screw

Sold individually.

$5.73

Washer

This part goes on the agitator retaining bolt.

$4.89

D-Shaped Knob Insert

This insert is sold individually. Knob not included. Knob is sold separately.

$12.10

Drive Block - 2 5/16" High

This part is for large capacity belt drive and direct drive appliances.

$5.24

Cap, Agitator

This is the cap for your agitator.

$5.51

Hose Clamp

The hose clamp is used to hold the water hose in place which will prevent the hose from leaking water. Sometimes the clamp may lose its ability to latch on, causing a leaking washer. For the installation, you will need a flat head screw driver to replace the clamp and a drill to access the screws to remove the front of the washer. Be careful if you do not have specific clamp pliers as the clamp could fly off. Once the front of the washer has been removed, take a quick look for water damage or any obvious signs of where the leak is coming from. If it is not obvious, run water to test.

All Parts for the RTW4640YQ0
1-14 of 110