Models > RTP306

RTP306 Maytag - Overview

Parts and Repair Help for models starting with RTP306

If you know the repair part you need, you can browse the list of all parts for models starting with RTP306, or you can search by name or part description. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Models starting with RTP306

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$52.92

Surface Burners Spark Module Kit

$27.42

IGNTR-SURF

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

GRATE, TOP BURNER

GROUNDING BRACKET

GRATE - AFTER SERIAL NUMBER 40

SPARK MODULE KIT

SWITCH, TOP BRNR ACTU

CONTROL PANEL

END CAP, CONTROL PANEL

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burners and gas oven would not light

  • Customer: nicholas from livermore CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 4 of 5 people found this instruction helpful
unplug the oven and pull it away from the wall. looking at the oven from the back, the spark module is at the bottom on the lower left. there is a two piece sheetmetal cover over the area of the spark module. use a phillips head screwdriver to remove five screws and the covers come off. the spark module is the blue cube with four push on wire connectors.... read more

The range burners would not catch a spark and ignite. They would just keep clicking with no ignition.

  • Customer: Adrienne from Lake Havasu City AZ
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers
  • 3 of 3 people found this instruction helpful
I had an appliance repair rep do the replacement. He made it look relatively easy.
The repair man first turned off the breaker to the range and confirmed there was no power to the range.
After lifting off the range top cover exposing the burner igniters, he unhooked and removed the igniters. He opened the lower oven door exposing the screws whi... read more

Igniters did not spark

  • Customer: Steve from Sedona AZ
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 2 of 2 people found this instruction helpful
Unplug and pull range away from wall.
Remove metal panel from back of range by using nutdriver to remove 4 screws.
Use phillips scewdriver to remove 2 screws holding old spark module.
Unplug 4 wires from spark module and note placement of wires for reinstall.
Install new module by reversing procedure.
Slide range back against wall an... read more