Quick Question!

Have you ever purchased from PartSelect.com before?

Models > RT21LMXKQ02

RT21LMXKQ02 Roper Refrigerator - Overview

Get Parts and Repair Help for RT21LMXKQ02

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT21LMXKQ02, or you can search by name or part description. You can also find your part by where it is located on the RT21LMXKQ02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT21LMXKQ02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$118.82

Replacement Ice Maker

***NOTE: Ice maker does NOT come with the bail or shut off arm. Must order them separately if required. It does come complete with flat and round plug wiring harness, the mountin...

$65.25

Icemaker Control Assembly

This part is used to help tell the icemaker what to do - it turns the timing cams and the ejector blades. Motor is not sold separately.

$7.60

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

$7.20

Touch-Up Paint - White

18ml

$35.17

Light Socket Kit

The bulb is sold separately.

$11.64

Ice Pan

This part may come in white or clear plastic, but either will still work and fit properly in your appliance.

$97.31

Fresh Food Door Gasket

This misty beige door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

$11.07

Spray Paint - 12 oz. - White

$7.20

Touch-Up Paint - .6fl Ounce - Biscuit

$44.80

Compressor Relay and Overload

May differ in appearance, but functions same as original. The overload protects a motor from overheating and the relay boosts the compressor.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Ice Maker quit working, I could manually cycle unit but then the water would overflow when unit was re-filling.

  • Customer: Max from Green Castle, IN
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 544 of 558 people found this instruction helpful
I backed out the 2 top screws about a quarter inch and then removed bottem screw with a quater inch nut driver. I then lifted Ice Maker clear of the two top screws and lowered it enough to unclip the power connection with a small screwdriver. The new Ice Maker was wired correctley for my refrigeator so all I had to do wea reconnect the power connection and... read more

No ice

  • Customer: Daniel from Suwanee, GA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 430 of 511 people found this instruction helpful
removed flap door in front of icemaker...removed 3 screws with bolt heads...removed one additional screw with bolt head and ice unit slid out. I removed motor unit (pops out no screws). Replaced and had ice within 3 hours. read more

The frost free feature of the freezer was freezing over with ice and cooling coils were being insulated with thickening frost which caused the cooling air to rise in temperature from -5 degrees to 20 degrees.

  • Customer: Lawrence from Grahamsville, NY
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 324 of 380 people found this instruction helpful
I troubleshot the problem by reading the electrical schematic and concluding the heating elements (defrost cables) were either defective or the bi-metal temp sensor was open. When closed the temp sensor completes the circuit for the current to flow through the heaters to defrost the cooling coils every 8 hours and then when the bimetal opens at 55 degrees t... read more