Models > RT20DKXDN02

RT20DKXDN02 Roper Refrigerator - Overview

Get Parts and Repair Help for RT20DKXDN02

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT20DKXDN02, or you can search by name or part description. You can also find your part by where it is located on the RT20DKXDN02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT20DKXDN02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RT20DKXDN02 [Viewing 5 of 5]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.58

Light Bulb - 40W

Sold individually.

$52.77

Crisper Pan

This crisper drawer is clear plastic. Sold individually.

$20.76

Bimetal Defrost Thermostat

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

$8.59

Light Rocker Switch

This light switch is triggered by the door opening and closing.

$4.77

Door Shelf Retainer Bar End Cap

$33.13

Handle End Cap Kit

This kit includes both upper and lower door handle end caps for both freezer and fresh food door handles. This is only available in chrome. All other colors are discontinued. Handle is NOT included. Handles must be ordered separately.

$4.34

End Cap Trim Piece

Sold individually.

$18.39

Light Socket Kit

The bulb is sold separately.

$2.07

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$62.62

Crisper Cover Frame

This is just the frame. The glass is sold separately.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 45 of 55 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

water dripping inside fridge due to drain hole being frozen over wiith ice.

  • Customer: Edwin from Maplewood NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 40 of 46 people found this instruction helpful
first I diagnosed the problem with the whirlpool do-it-yourself repair manual, which was very easy to understand. as per the repair manual, "this part located on the evaporator or the back of the liner is used during the defrost cycle. This bimetal senses the temperature from the evaporator. When the temperature reaches 50-70 degrees (F) the defrost bimetal... read more

Light Would Not Go On In The Refrigerator

  • Customer: DANIEL from MINNEAPOLIS MN
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 33 of 38 people found this instruction helpful
First I removed the old lightbulb from the socket and replaced it with a new one to confirm that the bulb was not the problem. I then pryed the socket out with a flat-head screwdriver. I could tell that the socket was anchored in its hole with clips so it was relatively easy to pry it out. Once the socket was out, I disconnected the lead wires and ordered... read more