Models > RT20AKXDW02

RT20AKXDW02 Roper Refrigerator - Overview

Get Parts and Repair Help for RT20AKXDW02

If you know the refrigerator repair part you need, you can browse the list of all parts on the RT20AKXDW02, or you can search by name or part description. You can also find your part by where it is located on the RT20AKXDW02 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for RT20AKXDW02 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the RT20AKXDW02 [Viewing 5 of 5]

$2.52

Light Bulb - 40W

Sold individually.

$27.13

Bimetal Defrost Thermostat

This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

$53.82

Crisper Pan

$3.96

End Cap Trim Piece

$3.76

Door Shelf Retainer Bar End Cap

$8.37

Light Rocker Switch

$5.54

Touch-Up Paint - White

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$61.37

Crisper Cover Frame

This is just the frame. The glass is sold separately.

$85.18

Condensor Fan Motor Kit - 60Hz 115V

This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan. Wire harness and hardware are included.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

water dripping inside fridge due to drain hole being frozen over wiith ice.

  • Customer: Edwin from Maplewood NJ
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 36 of 42 people found this instruction helpful
first I diagnosed the problem with the whirlpool do-it-yourself repair manual, which was very easy to understand. as per the repair manual, "this part located on the evaporator or the back of the liner is used during the defrost cycle. This bimetal senses the temperature from the evaporator. When the temperature reaches 50-70 degrees (F) the defrost bimetal... read more

Lights inside refrigerator not working

  • Customer: Clint from Rayville MO
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 36 of 43 people found this instruction helpful
I used a flat-head screwdriver to pop out the old light rocker switch. Then, I unplugged the wires, plugged them into the new light rocker switch, and then popped the new switch into the hole. That's it! Lights began working again. read more

Believed the condensor motor was defective and causing strange odor

  • Customer: Nicholas from Frankfort IN
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Socket set
  • 26 of 31 people found this instruction helpful
First disconnected the quick release electrical connection. Then loosened the three screws that were holding the motor in the bracket. However, space is limited and even with small hands it was rather difficult as the screws were in there very tight. There are a few sharp edges on the bracket and in the surrounding area of the motor area, and nicked mysel... read more